The H&R 72813 is a matched front and rear anti-roll bar set for the 964-generation Porsche 911 C2 and C4, with a 24mm front bar and a 26mm rear bar. Per the manufacturer, H&R Sport Sway Bars are crafted from a special (hf) 50CrV4 steel alloy. Each bar is cold-formed and heat-treated, with forged seamless bar ends, and the company also shot-peens the sway bars to increase durability. Production happens at H&R's ISO9001 certified manufacturing facility in Germany.
The case for paying for this kit over stock is handling without a ride penalty. The manufacturer says these bars improve a vehicle's lateral stability and cornering grip, while reducing body roll, and they are aimed at drivers who want that gain without lowering or affecting ride quality. For a 964 C2/C4 used on back roads or at track days, this is the search-friendly upgrade: 964 C2 C4 sway bar kit, Porsche 964 anti-roll bar 24mm front 26mm rear, and 911 964 cornering stability upgrade.
Fitment needs a careful check. Published year coverage is inconsistent, so confirm your model year, body style (coupe, targa or cabrio), and transmission with H&R before ordering. Install is a more involved job at the front: owners on user forums report that after loosening the brake booster there was clearance once the bar was properly installed. Forum advice on 964 bars also suggests raising both sides of the car together, because if you raise only one side at a time, there will be some pre-load on the bar making it a little more difficult to align the second link.
Published fitment details vary, and the product name reads 89-90 while other listings show a broader 1989-1994 range. Confirm your model year, body style and transmission with the manufacturer before ordering.
Owners on user forums report that the front bar can be tight near the brake booster. Several loosened the booster, seated the bar, and then returned the booster to its original position, reporting about 2-3mm of clearance afterward.
Owners on user forums advise lifting both sides together. Raising only one side preloads the bar and makes aligning the second drop link harder.
The rear bar is generally the easier swap. Forum advice from other Porsche chassis describes removing the hanger clamps and drop links, then lowering the bar out, and recommends fitting new drop links, hanger clamps and bushings at the same time. The front bar is more involved because of the brake booster clearance and drop-link alignment noted above. Work with the car safely supported, and confirm torque specifications with the manufacturer, since none were verified during this research.