The H&R 72819 is a front-and-rear anti-roll bar kit for the first-generation Volkswagen Jetta, with a 22mm front bar and a 26mm rear bar. It belongs to H&R's Sport Sway Bar range, which the manufacturer says is cold-formed and heat-treated, with forged seamless bar ends, and shot-peened to increase durability. The bars are made from the brand's 50CrV4 steel alloy.
The purchase case rests on roll control rather than ride height. The manufacturer positions the Sport bars to improve handling without lowering or affecting ride quality, which suits an MK1 owner who wants sharper turn-in and flatter cornering without coilovers or a lowering spring. Stock bars give up a lot of that stiffness, and the kit's bushings are urethane/Teflon composite, which prevents squeaks and eliminates the need for lubrication. Fitment should be checked before ordering: the Jetta 1980-1984 range is covered, while Rabbit and Cabriolet entries vary, so confirm your exact submodel with the manufacturer. Search terms this kit matches include MK1 Jetta sway bar kit, 22mm front 26mm rear anti-roll bar, and 1980-1984 Jetta handling upgrade.
No. The manufacturer describes the Sport sway bars as adding roll resistance while leaving ride height and ride comfort unchanged.
The manufacturer states that H&R Sport sway bar kits include the brand's urethane/Teflon bushings, so the bushings are part of the kit.
Fitment is listed for 1980-1984 Volkswagen Jetta submodels, including the Base, GL, GLI, Special Edition, and Wolfsburg Edition. Rabbit and Cabriolet coverage varies, so confirm your exact year and submodel with the manufacturer before ordering.
This is a moderate driveway job that involves lifting the car safely on jack stands, removing the wheels, disconnecting the end links, unbolting the bushing brackets, and swapping the bars. I did not locate an install sheet from the manufacturer for this specific part, so confirm the procedure and torque values with the manufacturer's documentation. For the fasteners, use new hardware rather than reusing prevailing-torque nuts, and place a small amount of anti-seize compound on the mounting bolt's shaft where the design calls for it. Also never over torque fasteners when installing new sway bar links or bushings.