The H&R 71616 is a 27mm non-adjustable rear sway bar for the G80-generation BMW M3 and M4 Competition xDrive (AWD). It replaces the factory rear bar to add roll resistance at the back axle, which helps a heavy all-wheel-drive chassis hold its line through corners. The manufacturer lists it as a rear-only, non-adjustable bar, so the stiffness is fixed and needs no setup. A single rear bar also costs less than a full front and rear kit, which suits owners who want to test rear roll stiffness first. The manufacturer's application lookup lists this part for the G80 M3 sedan from 2021 to 2026, so confirm VIN-level fitment before ordering.
Track and performance buyers searching for a G80 M3 rear sway bar, M4 Competition xDrive anti-roll bar, or 27mm non-adjustable H&R sway bar are looking for a fixed-rate, German-made bar rather than a generic universal unit. Owners on user forums say that installing a rear bar on these cars is a moderate-effort job, not a quick swap. Plan on lifting the rear wheels and supporting the car on jack stands, and budget time for the sway bar brackets and end link hardware. Forum members also report that the end link geometry should be checked at ride height, so the end link and bar connection points form a right angle when the car sits on its suspension.
No. The manufacturer lists this rear sway bar as non-adjustable, so its stiffness is fixed at the 27mm diameter.
This listing covers the 2022–2023 BMW M3 and M4 Competition xDrive (G80, AWD). The manufacturer's application lookup also lists part 71616 for the G80 M3 sedan from 2021 to 2026. Confirm your exact model year and drivetrain with the manufacturer before installing.
Owners on user forums report that aftermarket rear sway bars on earlier BMW platforms often required lowering the rear subframe for clearance. Those reports come from other generations, so check the G80 installation requirements with the manufacturer before starting.
Owners on user forums describe this as a moderate-difficulty DIY job that requires jack stands, a torque wrench, and a helper for the bar and brackets. Remove the rear wheels, unbolt the end links from the bar, and hold the end link ball joint with a vise grip or padded vise while loosening the nut. Forum members note that the bar and bushing brackets can be tight to remove and that the new bar often goes in more easily once the subframe has some clearance. Torque values for the G80 rear bar were not confirmed in this research, so use the manufacturer's installation specifications for the final tightening.