The H&R 71788-26 is a 26mm non-adjustable rear sway bar built for the 2022 Volkswagen Golf GTI MK8. It replaces the factory rear bar with a thicker, stiffer unit that adds roll stiffness at the back of the car. Because the rate is fixed, there is no setup or tuning to do. For buyers who want more rear grip and a more rotational FWD response, that matters. Owners on user forums say the rear bar helps the MK8 GTI rotate more readily, especially on lift-off and trail braking, though the car gains a firmer feel over rough pavement. Compared with the 24mm H&R rear option, the 26mm bar is the more aggressive choice, so match it to your tire setup and driving style.
Search terms this bar answers include 2022 VW GTI MK8 26mm rear sway bar, non-adjustable rear anti-roll bar, MK8 GTI understeer fix, and H&R 71788-26 install. The manufacturer's application listing covers the MK8 GTI for 2022 through 2026, and the bar mounts to the factory points. Confirm your trim (S, SE, Autobahn, or 40th Anniversary) with the manufacturer before ordering, since application listings differ in detail.
No. The manufacturer lists this 26mm bar as non-adjustable, so it runs at one fixed rate. If you want to tune the rear bias, look for an adjustable rear bar instead.
The manufacturer's application listing covers the Volkswagen Golf GTI MK8 from 2022 through 2026. Confirm your exact trim with the manufacturer before ordering, because listings vary by trim.
User forums report that the rear bar is commonly run with the factory front bar, as the rear is the more common upgrade for MK8 understeer. Check with the manufacturer for any front and rear pairing guidance.
Rear sway bar swaps on the MK8 are a manageable DIY job for a home mechanic with a lift or jack stands, but expect a few tight spots. Owners on user forums report that the stock bar with its end links can be hard to clear the exhaust when removed, so many remove the bar and end links separately. The end link fasteners are often triple-square, so buy the correct socket before starting, and some owners found the end links hard to seat onto the new bar. A common tip from owners is to snug the bushings with the car sitting on its wheels, so the bushings are not preloaded at ride height. Use a torque wrench for final tightening and jack stands for safety.