Free Shipping on Orders Over $99  ·  No Code Needed

H&R 2019+ BMW 330i/430i/M340i/M440i 19mm Non Adj. Sway Bar - Rear

*Photo may not represent actual product

The H&R 71462 is a 19mm rear sway bar for the 2019+ BMW 330i, 430i, M340i and M440i, and it is non-adjustable. The manufacturer builds its Sport Sway Bars from 50CrV4 steel alloy that is heat-treated and shot-peened for tensile strength, with forged ends and urethane/Teflon composite bushings. Compared with the factory bar, the manufacturer says the stiffer bar increases roll resistance while keeping ride comfort, so you get flatter cornering without the harshness of a coilover-only setup. Search terms this part targets include H&R 71462 G20 rear sway bar, 19mm non-adjustable rear anti-roll bar, and BMW G20 330i rear sway bar upgrade.

Fitment varies by drivetrain and submodel across listings, so confirm your RWD or xDrive configuration and VIN with the manufacturer before ordering. Installation is not a simple bolt-in on this chassis. Owners on user forums describe lowering the rear subframe to free the bar, which means disconnecting thrust arm brackets, the rear differential harness and subframe bolts. Plan for a lift, jack stands and a torque wrench, and budget extra time if you are pairing this with a front bar for a balanced setup.

  • Manufacturer Part Number: 71462
  • Position: Rear
  • Diameter: 19mm
  • Adjustability: Non-adjustable
  • Bar Material: 50CrV4 steel alloy (heat-treated, shot-peened)
  • Bushings: Urethane/Teflon composite, no lubrication required
  • Application: 2019+ BMW 330i, 430i, M340i, M440i (G20/G22/G23 chassis)
  • Country of Origin: Germany

FAQ:

Can I adjust the stiffness of this rear bar?

No. This is the 19mm non-adjustable version. H&R's forged-end design allows adjustability only on certain vehicles, so check the application before assuming any tuning options.

Do I need to drop the rear subframe to install it?

Owners on user forums report that removing and installing the rear bar on the G20 requires lowering the rear subframe by several inches, which adds time and requires careful attention to brake sensor lines and other wiring.

Does this bar fit both RWD and xDrive G20 models?

Fitment details vary across sources. Confirm your drivetrain and VIN with the manufacturer before ordering.

Installing it yourself

This is an advanced DIY job. Owners on user forums describe a full subframe drop, with common fasteners including 16mm and 18mm bolts, a T27 or 16mm wrench for the end links, and 12mm sockets for the bar brackets. Forum torque references include roughly 80 ft-lb for the subframe bolts, 42 ft-lb for the end link nuts and 21 ft-lb for the bar brackets, though you should verify these against the manufacturer's service data. Support the differential with a floor jack and a block of wood, and do not jack the car from the differential cover, which can cause damage. Work on level ground with the vehicle properly supported on jack stands.

  • MPN: 71462
  • Manufactured by: H&R
  • Units per SKU: 1
  • In Stock: 3
Exclusive member pricing Free membership — sign in to see your price
Join Free →

$439.00

MSRP / List price
Member Price
Your price after signing in
$439.00
Only 3 left in stock — order soon
Add to Cart:
MPN
71462
Manufacturer
H&R
Availability
Only 3 left
Ships Same Day
Order before 5pm PST and this product ships same day
Member Pricing
Easy Returns
Expert Support
Secure Checkout