The H&R 71654 is a 25mm rear sway bar built for the BMW G30 5 Series, covering the 530i and 540i from 2017 through 2023 on cars without Active Stability Control. It replaces the factory rear anti-roll bar to raise roll stiffness at the back axle, which limits body lean through corners without changing ride height. For enthusiasts searching for a G30 540i rear anti-roll bar upgrade, it offers a targeted step up from stock handling.
Owners on user forums who have fitted larger rear bars to 5 Series BMWs commonly describe firmer body control and a more neutral balance, with some saying the change offsets factory understeer. A rear-only swap is also a lower-cost way to tune handling before committing to a full front-and-rear kit. For a G30 used for spirited road driving or autocross, this is a practical way to sharpen turn-in and reduce roll without a suspension overhaul.
The manufacturer designates this H&R part for vehicles without Active Stability Control, so confirm your car's equipment before ordering.
Owners on user forums working on comparable BMW rear bars report that the subframe usually needs to be lowered. A G30-specific procedure was not confirmed during research, so check a G30 install guide or contact the manufacturer before starting.
This is a moderate-to-advanced job rather than a simple bolt-on. Owners on user forums describe removing rear chassis braces, liners, and exhaust hangers as needed, unbolting the subframe, and lowering it enough to remove and reinstall the bar. Support the car on jack stands, lower the subframe slowly, and watch the brake lines and firewall. Owners suggest using two wrenches when loosening end-link nuts, since the link can spin. Plan for a second person and extra time.