The H&R 17-23 BMW 530i/540i G30 Sway Bar Kit pairs a 34mm front bar with a 25mm rear bar for G30 5 Series models. The manufacturer's application table lists the 34mm front bar as non-adjustable and fitted to vehicles without Active Stability Control. The rear bar is a two-hole adjustable design, so you can change how the car balances roll stiffness instead of accepting one factory setting. Larger-diameter bars resist body roll more firmly, which is the core handling gain over stock. Buyers searching for a G30 530i or 540i sway bar upgrade for corner-entry control should confirm their car has no Active Stability Control before ordering. Owners in one user-forum discussion of H&R anti-roll bars describe the outer hole as the softer setting and the inner holes as stiffer, so start in the middle and adjust from there.
Installation is a jack-stand job, and owners on user forums describe the bars as straightforward while the end links can be stubborn. One owner called it a pretty easy job that needs little beyond jack stands. Support both sides of the axle, or release both end links together, because loading one side can twist the bar and make a link pop loose. When changing rear holes, owners unbolt and remove the end links from the bar on both sides at once, then bolt them through the chosen holes. Expect the end link fasteners to take the most time.
The manufacturer's application data lists this kit for G30 models without Active Stability Control, so check your car's equipment before buying.
The manufacturer's application data lists the front bar as non-adjustable and the rear bar as two-hole adjustable. Published descriptions differ on this point, so confirm with the manufacturer before planning front-end tuning.
Owners on user forums describe supporting the car, releasing both rear end links together, and bolting them into the other hole on each side. Doing one side alone can load the bar and make the link release violently.
This is an intermediate driveway job that requires a jack, jack stands, and a set of wrenches and sockets for the end link and bar bracket fasteners. Owners on user forums say the end link fasteners can be the hardest part, so budget extra time and consider a penetrating lubricant. Work on both sides of the axle together, check that the bushings sit evenly on the bar, and torque fasteners to the manufacturer's specifications, or confirm the values with the manufacturer's install documentation before reassembly.