This H&R Sport sway bar kit is a matched front and rear set for the MK7 Golf R 2.0T AWD. The front bar is a 27mm unit with adjustable ends, paired with a 25mm rear bar. H&R Sway Bars are crafted from a special 50CrV4 steel alloy, and the bars are heat-treated and shot-peened for durability. Because the bushings are urethane/Teflon composite, they run without grease and resist squeaks, which matters on a daily-driven car that sees track or autocross days. Compared with a single rear bar, the kit lets you rebalance the whole car's roll stiffness, not just the rear axle. Search terms owners use include MK7 Golf R sway bar kit 27mm front 25mm rear, adjustable front sway bar Golf R AWD, and Golf R understeer fix.
Owners on user forums describe the rear bar as the easier and more common first step, and the front bar as the more involved one. Adding the front bar gives you the adjustable end-link option, so you can tune cornering rotation without touching the coilover settings. The kit is also designed to keep the ride comfortable, so it is not meant as a stiff track-only setup. Fitment is listed for the 2015 to 2019 or 2015 to 2020 Golf R depending on the seller, and sources do not fully agree on model years and trims. Confirm your VIN or chassis against H&R's current fitment guide before ordering.
Owners on user forums report reusing the factory rear end links with the H&R rear bar without trouble, though worn or brittle plastic OE links are a common reason to replace them.
The manufacturer lists the front 27mm bar as adjustable with two holes, while the 25mm rear bar is non-adjustable.
The rear bar is the more approachable job. Owners on user forums say the front bar is much more involved because the subframe has to be lowered to clear the bar, and some recommend replacing the subframe bolts or a dead-set kit while it is down. Plan on a floor jack, jack stands, and a full socket and torque set. Expect a stubborn fit when seating the end links into the bar holes. One owner on a user forum had to pry the end link into position with a flat screwdriver, so keep a pry bar handy. Confirm torque specs with the manufacturer's install instructions before tightening.