The H&R 70474 is a 30mm front anti-roll bar for the BMW F87 M2 that replaces the factory front bar. The manufacturer states that H&R sport sway bars are cold-formed and heat-treated from a high-tensile 50CrV4 steel alloy, with forged ends and a shot-peened surface for durability. Each bar is built at H&R's ISO9001-certified facility in Germany, and the powder-coated finish helps resist corrosion.
Compared with the stock bar, this unit lets you adjust roll stiffness through its two end-link positions, so you can run it softer for daily driving or stiffer for track days. The manufacturer says its sport bars raise roll stiffness while keeping ride comfort close to stock, which is the main reason to pay for this over a generic bar. Owners on user forums compare it to the M2 CS Racing front bar and report that the two are very similar in design, a useful benchmark if you are weighing a budget option. Confirm the bushing package before ordering, since listings differ on whether bushings ship with this part number.
The bar targets the F87 M2 chassis, including the N55 base car and the S55 Competition and CS variants. Year coverage is listed differently across sources, so verify your VIN-specific fitment before buying. Search terms this bar matches include H&R 70474 F87 M2 front sway bar, 30mm adjustable front anti roll bar M2 Competition, F87 M2 N55 front sway bar upgrade, and M2 track day body roll control.
Year ranges and trim coverage are listed differently across sources, so the manufacturer should confirm your exact application before you order. Check your VIN and model variant against the manufacturer's fitment information.
Yes. The manufacturer states that multi-hole adjustment on most H&R anti-roll bars lets you influence handling balance, such as roll tendency and understeer or oversteer. Moving the end links to a different hole changes the effective stiffness.
The manufacturer describes H&R sway bars as using composite rubber bearings. Confirm with the manufacturer whether bushings are included with this part number, since listings disagree.
Owners on user forums say the front bar on the F87 M2 sits under the subframe, so it can be swapped without dropping the subframe as on the regular 2 Series. A typical sequence from owner install guides is to remove the underbody panels, disconnect the end links, remove the bar brackets and bushings, fit the new bar, and reconnect the links. Plan on jack stands or a lift, and standard sockets and wrenches. Set the end links to your chosen hole before final tightening, and avoid preloading the bar. Follow the torque values in the manufacturer's instructions.