The H&R 71787-26 is a 26mm non-adjustable rear sway bar for the MK7 Volkswagen Golf and GTI, built as a solid bar from (hf) 50CrV4 steel with forged ends. The manufacturer says the bar is heat-treated and shot-peened for tensile strength, and that its German plant holds ISO 9001 certification. It replaces the factory rear bar to add roll stiffness, which reduces body roll and firms up cornering grip without lowering the car. For MK7 owners who want a fixed, repeatable rear rate with no adjustment hardware to maintain, it is a straightforward step up from stock.
Owners on user forums who fitted a 26mm H&R to a MK7.5 GTI reported more lift-off oversteer, a tighter steering feel, and slightly less initial understeer, with no ride penalty they could detect. Other owners note that a bar this size shows its value most on a track or on fast canyon roads, and that it can be more than a daily driver needs. The manufacturer describes its urethane/Teflon bushings as squeak-resistant and lubrication-free. Search terms this bar matches include H&R 71787-26 MK7 rear sway bar, 26mm rear anti-roll bar Golf GTI, and MK7 GTI rear sway bar upgrade.
The fitment details I could confirm point to Golf and GTI trims with the S, SE, SEL, and 1.8T designations. I found no confirmation for Golf R or AWD applications, so check with the manufacturer before ordering.
Owners on user forums disagree. Some report that factory end links are fine unless they have perished, while others replace them at the same time as the bar to avoid future noise or failure.
The manufacturer describes its urethane/Teflon bushings as squeak-resistant and requiring no grease. It also states that most applications include them.
Installing this rear bar is a moderate DIY job that calls for a lift or jackstands, wheels removed, and a metric socket set with triple-square bits, since the bar bolts to subframe brackets and links to the control arms through end links. A comparable MQB rear-bar guide from another manufacturer estimates about two hours, and some of those guides note that the rear exhaust hangers may need to be lowered for clearance. Owners on user forums advise replacing stretch bolts on the Golf suspension, not reusing them, and tightening the end-link nuts with the wheels on the ground and the car loaded. Check the end links for perished rubber or play before reinstalling.