The H&R 70340 is a 27mm, two-hole adjustable front sway bar for the 2015–2019 Audi A3 Sedan Quattro and S3 (8V, AWD). It belongs to H&R's Sport Sway Bar line, which the manufacturer makes from high-tensile 50CrV4 steel alloy that is heat-treated and shot peened. The main reason to choose it over the factory bar or a cheaper fixed-rate bar is handling control. H&R says its bars reduce body roll for tighter turn-in while keeping the tires connected to the road without sacrificing ride quality, and the two-position ends let you tune the setting rather than accept one fixed compromise. Its forged ends and urethane/Teflon composite bushings are designed to prevent squeaking. Fitment is the first thing to verify. Published charts list 2015–2019 A3 Quattro trims, but some also show a 2020 S3 and certain VW applications, so confirm your year and trim with the manufacturer's fitment guide before ordering. Owners on user forums describe the front bar as the easier of the two H&R bars to swap, and recommend removing the underbody splash shield for access. Searchers looking for "8V S3 adjustable front sway bar install" or "A3 Quattro 27mm two-hole sway bar" will find this bar's stiffness setting and routing are the main points to get right.
Owners on user forums report that the outermost holes give the softest setting, so moving the link outward reduces stiffness. Confirm the hole mapping for your application with the manufacturer before final setup.
The manufacturer describes the bushings as a urethane/Teflon composite designed to prevent squeaking. Check the manufacturer's install documentation for any lubrication guidance.
Owners on user forums rate the front bar as a manageable DIY job, with the car raised on ramps or a lift and the underbody shield removed for access. Plan on sockets, a jack and stands or ramps, and a way to reach the bar ends. The most common gotcha is routing: one owner found the bar must pass above the tie-rod, not below it, and had to reverse the bar. Reinstall the plastic splash shield carefully afterward, since forum owners note it can be misaligned.