The H&R 26mm Adjustable Front Sway Bar (part 70787-26) is a front anti-roll bar for the MK7 Volkswagen Golf and GTI, designed for the front-wheel-drive platform. Its 26mm diameter is a step up from the factory bar, and the two-hole adjustment lets you change how firmly the front end resists body roll. For a buyer searching for a MK7 GTI front sway bar for sharper turn-in and flatter cornering, the front bar is where the handling payoff starts, because it stiffens the axle that carries most of the braking and steering load.
Owners on user forums who paired H&R's 26mm front bar with a 24mm rear bar describe the front change as the more noticeable of the two, with clearly reduced body roll and no major increase in harshness on daily commutes. Compared with a cheaper unbranded bar, this kit's value lies in the consistent steel, bushings, and build quality that H&R sells as its core spec, so it suits track-day, autocross, and spirited street drivers who want predictable adjustability rather than a guess-and-check setup. Shoppers looking for a 2015-2019 Golf GTI S/SE/SEL or 1.8T adjustable front sway bar will find this is the part that matches that search.
The manufacturer's application listing for this part covers the 2015-2019 Volkswagen Golf and GTI MK7 in S, SE, SEL, and 1.8T trims. Confirm your exact trim and model year against the listing before ordering.
The bar is described as two-hole adjustable. The specific stiffness difference between the two holes was not confirmed in our research, so check the H&R instructions included with the kit before choosing a setting.
Owners on user forums describe the front bar as more involved than the rear bar, usually because the front subframe has to be lowered to get the old bar out and the new one in. Those accounts came from Golf R owners, so expect similar steps on a non-R GTI rather than a simple bolt-in swap. Forum owners list the main jobs as dropping the subframe, removing the end-link nuts at the strut towers, disconnecting the control arm knuckle nuts, and unbolting the downpipe hanger. Plan for a lift or secure jack stands and a full socket set, and confirm torque specs and hole selection in the H&R instructions before you start.