The H&R 70878-3 is a 28mm front sway bar for the F33 BMW 435i xDrive Cabrio, built from 50CrV4 spring steel and adjustable through two end-link positions. It replaces the factory front bar to cut body roll and sharpen turn-in on an AWD chassis that is heavier up front than the RWD models. The manufacturer describes the bar as thicker than stock and made in Germany, with forged ends that allow stiffness tuning on applicable vehicles. The bushings are urethane/Teflon composite, so they should not squeak or need grease, which makes this a lower-maintenance upgrade than a stock rubber-bushed bar. Buyers searching for a 435i xDrive Cabrio F33 front sway bar, adjustable 28mm BMW sway bar, or F33 xDrive handling upgrade will find this bar matches that need.
Installation is a bolt-in job with the factory mounting points, and the bar's end-link positions let you dial in the front roll stiffness. Owners on user forums report that the lower end-link nut on xDrive cars is tight to reach, so plan for extra clearance and proper support of the control arm when you unload the links. Check the fitment with the manufacturer's vehicle selector before ordering, because application listings vary by year range.
Fitment data lists this bar for the F33 435i xDrive Cabrio in the 2014–2016 range. Some application lists also cover related F32 and F36 xDrive models, so confirm your exact chassis and VIN with the manufacturer's vehicle selector before ordering.
The manufacturer states that the urethane/Teflon composite bushings are designed to run without lubrication and to resist squeaking.
This bar is designed to replace the factory front bar at the existing mounting points, so it is a direct-fit swap rather than a modification. Work on level ground, lift the front evenly, and support the vehicle on jack stands. Owners on user forums warn that the lower end-link fastener is cramped on xDrive cars, so a flexible ratchet, extensions, and a penetrating lubricant help. Inspect the factory hardware and replace any worn parts before reassembly. Torque all fasteners to BMW specification, and confirm whether your car needs a wheel alignment afterward, since specific guidance was not confirmed in this research.