The H&R 72878-2 is a matched front and rear sway bar kit for the 2014-2016 BMW 435i Coupe F32, sized at 28mm front and 20mm rear. The front bar offers two-hole adjustability, while the rear bar is fixed, so you can tune roll stiffness mainly at the front. H&R's bars are designed to increase roll stiffness, which limits body roll in corners without a lowering effect on ride height. This kit suits drivers searching for a BMW F32 435i sway bar kit, 28mm front sway bar, or 435i coupe handling upgrade.
The reason to pay for this kit over stock bars is the added roll resistance from a larger diameter. Owners on user forums say the 28mm front bar works well, but they also warn that the 20mm rear can be too stiff for some setups and may lift the inside rear tire in hard cornering. If you want a softer rear, the manufacturer's part listings show the front (70878-2) and rear (71878) bars sold separately, so you can pair the 28mm front with a thinner rear. Adjustable end links are also worth considering if you change ride height, because they help remove preload from the bar.
The manufacturer's application listing for this kit covers the rear-wheel-drive 2014-2016 435i Coupe. xDrive models use a separate kit under a different part number, so confirm your drivetrain before ordering.
Yes. Owners on user forums note that H&R sells its front and rear bars individually, which lets you run the 28mm front with a thinner rear bar. The manufacturer's listings show the front bar as part 70878-2 and the rear bar as part 71878.
Details vary. Owners on user forums report that the 20mm rear can be more than some setups need and can reduce tire contact in heavy cornering. Confirm the right rear bar size for your setup with the manufacturer.
This is a moderate driveway job that needs jack stands or ramps, basic sockets, and a 16mm wrench for the rear end link nuts. Per forum DIY threads, the rear bar requires lowering the rear subframe to clear the bar, and removing the rear shocks gives you room to disconnect the end links. Front bar work centers on the end links and bracket hardware. Set the bar at rest when you connect the end links, because preload can cause clunking. Confirm torque values on the manufacturer's installation instructions before tightening.