Free Shipping on Orders Over $99  ·  No Code Needed

H&R 12-15 BMW 320i Sedan/328i Sedan/335i Sedan F30 20mm Non Adj. Sway Bar - Rear

*Photo may not represent actual product

This H&R 20mm non-adjustable rear anti-roll bar is built for the F30 BMW 3 Series sedan in 320i, 328i and 335i form. It replaces the factory rear bar with a thicker, fixed-rate unit meant to reduce body roll when you push through corners on a lowered or performance-tuned chassis. Owners on user forums say the rear end feels more planted and tends to rotate more readily out of a corner, which is the main reason enthusiasts fit it. Compared with a cheap generic bar, the advantage is that H&R designs its front and rear bars as a matched set, so the rear diameter is sized to work with the front bar rather than being guessed at.

Fit and stiffness are the key checks. Owners on user forums report that the 20mm rear can feel firm on rough pavement, and some have stepped down to a thinner rear bar, noting that a very stiff rear can lift one inside wheel under hard cornering on bumps. Pair it with your spring and damper setup, and confirm with the manufacturer that your trim, drivetrain (2WD or xDrive) and suspension package match this part number before ordering. Search terms this part answers include H&R 71878, BMW F30 320i 328i 335i rear sway bar, 20mm rear anti roll bar, non adjustable rear sway bar, and F30 sedan handling upgrade.

  • Manufacturer: H&R
  • Part Number (MPN): 71878
  • Position: Rear
  • Bar Diameter: 20mm
  • Adjustability: Non-adjustable (fixed)
  • Fitment: BMW F30 3 Series Sedan, 320i / 328i / 335i (confirm trim and drivetrain with the manufacturer)

FAQ:

Do all F30 320i, 328i and 335i sedans have a factory rear sway bar?

Details vary. Discussions on user forums indicate that rear bar equipment differs by trim and suspension package, so confirm fitment with the manufacturer for your specific car before ordering.

Will the 20mm rear bar feel too stiff for a daily-driven car?

Owners on user forums describe the 20mm rear as firm, especially on rough roads and at high speed. Some have switched to a thinner rear bar for a softer ride, so consider your daily-driving priorities against your handling goals.

Can I replace just the bushings on this bar?

According to user forums, the rubber bushings are bonded to the bar on F30 models, so worn bushings usually mean replacing the entire bar.

Installing it yourself

Owners on user forums describe the rear bar as a moderate-difficulty job, far easier than the front but not a simple jack-stand swap. The rear subframe generally needs to be lowered to clear the bar, and xDrive cars may require the exhaust to be moved. One DIY write-up estimated about two hours at roughly 6/10 difficulty, using E-torx sockets, 8mm and 16mm sockets, a jack, jack stands and a vise-grip. Watch for the sway link bolts, which spin freely unless you hold the opposite side. Confirm torque specifications with the manufacturer's installation documentation before reassembly.

  • MPN: 71878
  • Manufactured by: H&R
  • Units per SKU: 1
  • In Stock: 7, On Order: 2
Exclusive member pricing Free membership — sign in to see your price
Join Free →

$349.00

MSRP / List price
Member Price
Your price after signing in
$349.00
In Stock — ships same day if ordered before 5pm PST
Add to Cart:
MPN
71878
Manufacturer
H&R
Availability
In Stock (7)
Ships Same Day
Order before 5pm PST and this product ships same day
Member Pricing
Easy Returns
Expert Support
Secure Checkout