The H&R 72111 is a matched pair of anti-roll bars for the Porsche 911/997 Turbo, with a 26mm front bar and a 24mm rear bar. The bars are cold-formed and heat-treated, with forged seamless bar ends, and they are made from 50CrV4 spring steel. Each bar is shot-peened for durability. Bushings are H&R's urethane/Teflon composite, which the manufacturer says needs no lubrication and reduces squeaks.
Compared with the stock 19mm front bar, owners on user forums report that the thicker H&R front bar made the car firmer, with noticeably less roll in the bends. The result is a sharper turn-in and more cornering control without a lowered ride height. Front adjustment positions are described on the product listing, so a track setup can be fine-tuned. Choose this kit over a cheaper, undersized bar when you want a stiffer, track-ready 997 Turbo chassis that is still usable on the street.
No. The later car uses a separate H&R kit, part number 72111-2. Confirm fitment with the manufacturer before ordering, since listings vary on the model year range for part 72111.
The manufacturer states that the urethane/Teflon bushings need no lubrication. Owners on user forums still recommend checking the bushing mounts when the bar is reinstalled.
Owners on user forums report that the drop links can wear out, since they get a beating and corrode. Inspect them during installation and replace them if they are worn.
Owners on user forums describe the rear bar as the easier job. The front bar is more involved: the front subframe is held by 8 bolts, and owners note that loosening them lets the subframe droop enough to slide the bar out. Some owners report success removing the front bar without dropping the subframe, but it takes patience and it can scratch hands and parts. Keep the bushings clean and check the drop links while the bars are off. Because the work involves the front subframe, a shop with alignment equipment may be the safer choice for a first-time installer.