This H&R 24mm rear sway bar (MPN 71188) is built for 2005-2012 Porsche 911/997 Carrera coupe and cabriolet models without PDK. It replaces the factory rear bar and uses four adjustment holes, so you can change how much the rear end resists body roll. Owners on user forums describe H&R rear bars as stiffer than the factory unit. Stiffening the rear also increases oversteer (less understeer), so the hole you choose matters on a 997.
The adjustability is the main reason to pay more than for a basic bar. Owners on user forums commonly use the middle setting for street and stiffest setting for track, and one forum member reports shaving 5 seconds at Thunderhill Raceway after installing an H&R rear bar. Published fitment start years vary between 2005 and 2006, so confirm your car by VIN with the manufacturer. Owners also note that if you have PDK a GT2 or even GT3 rear sway bar will not fit. As pointed out the rear crossmember on PDK cars is different.
Owners on user forums report that PDK-equipped cars use a different rear crossmember, so this non-PDK bar is not intended for them. Confirm the correct part for your transmission with the manufacturer before ordering.
Forum members recommend replacing worn stock drop links during the job. One owner said the stock ones look like they will not do the job, so new links are a sensible addition.
Owners on user forums commonly run the middle hole for street driving and the stiffest hole for track use. Because a stiffer rear increases oversteer, change one setting at a time and retest.
This is a manageable driveway job for a home mechanic. One forum member reports that it took 1 1/2 hours to install a rear sway bar, and the drop-link bolts are the fiddly part: you need an allen wrench for the bolts on the drop links to the sway bar. The drop link bolts are a pain. Forum install guides list a socket set in the 14 to 18mm range and polyurethane grease, and they note that the bushings should be nice and greasy before installation. Per user forums, the bar should be fastened to the links with the suspension loaded to ensure noise-free operation. Follow Porsche torque specifications for all fasteners.