The H&R 71655 is a 26mm rear sport sway bar for the Ford Mustang, and it is a non-adjustable unit with a fixed stiffness rate. The manufacturer's table lists it for 2005-2009 Mustang V6 and V8 coupe and convertible models, including GT, Shelby GT and GT-H trims. It also forms the rear half of H&R's 72655 kit, which pairs it with a 36mm front bar that is adjustable, so you can source a matched front and rear setup from one brand.
Choose this bar over a cheaper generic rear bar when you want a brand-specific part number with a fixed, predictable rate and no adjustment holes to second-guess. For a sway bar install, owners on user forums advise lubricating the bushings well before assembly to prevent squeaks, and one owner noted that it would be a good time to change the shocks, that's what i did too, makes it easier to mount the swaybar with the shocks off. Searches for "2005-2009 Mustang H&R 26mm rear sway bar," "71655 Mustang rear anti-roll bar," and "Mustang convertible rear sway bar non adjustable" match the fitment and rate details buyers are typically comparing.
The manufacturer's application table lists 71655 as a rear bar for the Mustang Convertible and for the coupe GT, Shelby GT and GT-H, in V6 and V8 form, for 2005-2009. The same table also lists this part number for 2010 and 2011-2014 Mustangs, so confirm your exact year and trim with H&R before ordering.
No. The manufacturer lists the 26mm rear bar as non-adjustable, while the 36mm front bar in the matching kit offers adjustment.
This is a bolt-on rear swap that is manageable for a home mechanic with a lift or jack stands. Owners on user forums recommend greasing the bushing bores and contact points generously so the bar does not squeak, and removing the rear shocks can make it easier to seat the bar. Confirm bolt sizes, bushing orientation and torque values against the H&R install instructions included with your bar before you start.