The H&R 72414 is a matched pair of anti-roll bars for the 2001-2006 BMW M3 (E46), covering both the coupe and the Cabrio. The manufacturer's description says the bars are cold-formed and heat-treated from 50CrV4 spring steel, shot-peened, and finished with forged seamless ends. Upgrading to a 30mm front and 25mm rear bar increases roll stiffness, so the car resists body roll through corners while keeping ride quality closer to stock. Owners on user forums say the front bar makes the most noticeable change, and some track drivers keep the factory rear bar, so the rear is worth weighing against your budget. Compared with cheaper poly or generic bars, the manufacturer's urethane/Teflon bushings are designed to stay quiet without grease. That lets you skip the lubrication routine that many budget bushings need.
Keywords: E46 M3 coupe and convertible sway bar, 30mm front 25mm rear anti-roll bar, S54 3.2L handling upgrade, H&R 72414 installation.
The manufacturer lists this kit for the 2001-2006 M3 only. User forums report that the M3 rear bar does not bolt onto non-M E46 cars without modifying the factory mounts, while the M3 front bar is the one most often swapped onto non-M cars. Confirm fitment with the manufacturer before ordering for a non-M car.
Per the manufacturer, the urethane/Teflon bushings are designed to run without lubrication and to prevent squeaks.
Owners on user forums describe the front bar swap as straightforward and not especially difficult for a home mechanic. The rear bar takes more effort. Forum owners recommend removing the wheels, since the endlink bracket on the upper control arm is much easier to reach that way. The factory endlinks can be stubborn, and one owner needed a vise and penetrating lubricant to free them. Clearance between the new rear bar and the half shafts looked tight at full droop, but it was fine once the car was back on the ground. Plan for a vise, penetrating lubricant, and enough time to work the rear brackets carefully.