The H&R 72431 is a matched front and rear anti-roll bar kit for the MK4 Volkswagen Golf and Jetta 4Motion, with a 25mm front bar and a 21mm rear bar. The manufacturer says the bars are cold-formed and heat-treated from (hf) 50CrV4 steel, with forged seamless ends and a shot-peened finish. Stiffer bars resist body roll in corners, which sharpens turn-in and grip, and the manufacturer says ride comfort is maintained. Stock bars are the baseline here, and this kit's larger diameters and urethane/Teflon bushings are what separate it from a cheaper generic set. Search terms like MK4 4Motion sway bar kit, 25mm front 21mm rear, and 72431 H&R fitment will match this part.
Compared with a single front or rear bar, a matched pair keeps the car's roll balance consistent through a corner. The bushings are urethane/Teflon composite, which the manufacturer says prevents squeaks and needs no lubrication, so the kit stays quiet without regular maintenance. Fitment is the main purchase decision: published application data varies between sources, so confirm your model year, drivetrain, and trim before ordering. Installation is a moderate driveway job for an experienced DIYer, and it is best done with the manufacturer's install sheet on hand.
Published fitment data is inconsistent. Some listings describe the kit as AWD 4Motion only, while others show a wider range of trims. Confirm your drivetrain, trim, and model year with the manufacturer before ordering.
The manufacturer states the urethane/Teflon composite bushings prevent squeaks and eliminate the need for lubrication.
The manufacturer says the forged bar ends allow stiffness adjustability for specific vehicles. Whether your application supports adjustment should be confirmed with the manufacturer.
Owners on user forums who have swapped similar VW and Audi sway bars describe the job as manageable in a driveway with basic hand tools, though it takes a few hours solo. Forum members recommend cleaning the bolt threads and using a medium-strength threadlocker on threaded fasteners, since factory threadlocker can remain on the original bolts. The manufacturer advises that H&R suspension components be installed by a qualified, licensed mechanic experienced with aftermarket suspension, so if you are not confident, have a shop do the work. Use the manufacturer's installation instructions for torque specifications.