The H&R 71431-21 is a 21mm adjustable rear sway bar (anti-roll bar) for the 2000-2004 Volkswagen Golf 4Motion and Jetta 4Motion MK4. It replaces the factory rear bar and is built around a two-hole adjustable design, so you can change how stiff the rear end feels without buying a second bar. Owners on user forums say a stiffer rear bar reduces understeer and brings the car closer to neutral in corners, which is the main reason to upgrade the rear before the front on an AWD MK4. Compared with universal bars that require drilling into the rear beam, owners describe this bar as a no-drill fit that uses the stock mounting points.
Search terms this part targets include MK4 Golf 4Motion rear sway bar 21mm, adjustable rear anti-roll bar 2000-2004 Jetta 4Motion, VW MK4 AWD rear swaybar upgrade, and H&R 71431-21 install. Fitment matters here: the 4Motion designation points to the AWD rear suspension, and application tables vary between sellers, so confirm the 4Motion requirement with H&R before ordering. Owners on user forums report that the bushings supplied with H&R bars are Teflon-coated rubber, so check the kit contents against your existing hardware when you open the box.
Owners on user forums describe the MK4 rear bar installation as straightforward, with no drilling into the rear beam required. Confirm the exact hardware included in your kit before starting the job.
Owners on user forums commonly recommend starting on the softest setting, driving the car, and then moving to a stiffer position if needed.
Owners on user forums advise inspecting the end links during the install, since worn links can make a new sway bar feel loose or noisy.
This is a manageable weekend job for a home mechanic with a basic socket set and a jack with jack stands. Support the car securely, remove the wheels for access, disconnect the rear end links, unbolt the bar's mounting brackets, and slide the old bar out. Install the new bar with the bushings seated correctly, reconnect the links, and tighten all fasteners to the torque specified in the manufacturer's service information. Use the softest hole first, then test-drive and adjust. Because adjusting the hole position changes effective stiffness, re-check clearance and link alignment after any change.