The Baja Designs 451004 is a 10-inch bar from the OnX6+ straight LED line, built around six LEDs behind a hard-coated polycarbonate lens and a black aircraft-grade aluminum housing. The manufacturer lists the housing as aircraft grade aluminum with a mil-spec hard anodize, a billet machined aluminum bezel, and stainless steel mounting hardware. The bar uses the brand's High Speed Spot reflector design, and the manufacturer says its MoistureBlock technology keeps the light bar waterproof and dustproof. Owners on user forums say it delivers more usable light per watt and per square inch than cheaper bars, and they describe the housings as extremely durable. That durability is what justifies the premium over budget bars, especially for trail or desert buyers who need a 10-inch bar that will survive dust and wash-downs. Search terms that fit this product include OnX6+ 10 inch LED light bar, 451004 wide cornering bumper light, and IP-rated LED light bar with MoistureBlock.
Fitment is listed as universal, so this bar is meant for aftermarket mounting systems rather than a specific vehicle bracket kit. The manufacturer notes that the mounting brackets can be used in any application. Because the bar is sold without a harness, plan your wiring before you order. For a 10 to 20 inch OnX6+ bar, the manufacturer points to harness 640115. The manufacturer also notes that you can change damaged lenses or customize the beam pattern without voiding the warranty through its uService design. The brand states it offers a lifetime warranty against manufacturer defects on its products.
No. The manufacturer states that the wiring harness is not included with this light bar, and it specifies harness 640115 for 10 to 20 inch OnX6+ bars.
Yes. The manufacturer says damaged lenses can be changed through its uService design without voiding the warranty.
The manufacturer lists the 451004 as universal, so it mounts with the included stainless steel brackets on any suitable bumper, grille, or light-support system rather than on a single vehicle-specific bracket.
The manufacturer describes installation as straightforward thanks to the included universal brackets, and it publishes an installation sheet for the 451004. Owners on user forums who mounted it in a grille or bumper opening report removing the upper shroud clips, sliding the bar in from the top, and securing the brackets to the bumper with 14mm bolts. Plan to keep the bumper off the vehicle long enough to dial in the aim, because one owner found that adjusting the angle later required removing it entirely. Another owner noted that the plastic grille may need material trimmed so the bar fits. When you reassemble, route the harness carefully so no wires get pinched. On a Can-Am light support bar, one owner had to flip the brackets inward to fit. Have a 14mm socket, a trim tool for the clips, and the harness on hand before you start.
