The Baja Designs 270015 is a 6-inch LP6 Pro auxiliary light pod with a clear driving/combo lens and a blue backlight. It pairs six forward-projecting LEDs with four Integrated Peripheral Technology (IPT) LEDs that spread usable light to the sides, and the manufacturer's Direct Ducted Cooling design routes airflow over the rear heat sinks. Compared with a stock or budget pod, the appeal is sealed, serviceable build: MoistureBlock sealing rated for submersion, a hardcoated polycarbonate lens that can be swapped through a lens kit without voiding the warranty, and a limited lifetime warranty. The blue backlight is for custom show and photo builds. Searches such as "LP6 Pro blue backlight driving combo pod," "6 inch LED light pod 11225 lumens," and "uService replaceable lens LED pod" match this part.
Fitment is universal rather than vehicle-specific, so the pod suits bumpers, roof racks, A-pillars, or UTV mounts, and it includes a swivel bracket and stainless steel hardware. Plan for a separate wiring harness, since the pod is sold without one and the harness must match the pod's connector. Confirm the harness and install sheet for your application before ordering.
The manufacturer offers an LP6 Pro lens kit that replaces the lens without voiding the light's warranty. Kits are available in clear, Baja amber, and factory amber, and in spot or driving/combo patterns.
The manufacturer lists the LP6 Pro as a universal fit. Mounting hardware and a swivel bracket are included, so it can be installed on many different vehicles and mounting locations.
The manufacturer publishes installation sheets for the LP6 Pro universal series, so check the sheet for the 270015 before starting. Because the pod comes with a swivel bracket and stainless steel hardware, mounting is mainly a matter of choosing a location and running the wiring. Confirm the harness requirement before you begin, and keep the rear of the housing unobstructed so the cooling airflow is not restricted. Use a light-duty drill and fastener kit suited to your mounting surface, and verify polarity and the ground connection before you connect power.
