The Baja Designs LP4 Pro Spot in clear (part 290001) is a single auxiliary pod built on the brand's compact LP4 Pro platform. The Baja Designs LP4 Pro, the smallest variant in the LP lineup, maintains the power and features of its siblings. The manufacturer's listing states a total of 8,857 lumens and a 200-degree spread of usable LED light, with 6,885 forward-projecting lumens and 1,972 lumens of dedicated peripheral lighting. Choose this spot pattern over a generic pod when you need reach at speed: its 6° high-speed beam throws light far down a trail or road. The hardcoated polycarbonate lens, hard-anodized housing, and stainless hardware are built for durability, with exceeds MIL-STD810G (Mil-Spec Testing) and IP69K (Waterproof up to 9ft and Pressure Washable) ratings, plus a rated LED Life Expectancy: 49,930 Hours.
This clear-lens spot fits a wide range of rigs, from Jeeps and trucks to UTVs and motorcycles, and the manufacturer lists it as Universal fitment. Baja Designs positions the spot pattern as a companion to wide driving lights, so pairing it with a wide light gives you near-field spread plus long-distance reach. Searching for an LP4 Pro spot 290001 clear, a 6 degree spot light pod, or an IP69K auxiliary pod? This is the single-light version, so buy a second unit for a matched pair on A-pillar, bumper, or light bar mounts.
No. The manufacturer states that this light does not come with a wiring harness. The applicable wiring harness for this light is 640175.
Yes. The manufacturer's LP4 Pro install sheet describes removing the bezel and lens after loosening four bolts with a 4mm Allen wrench, then reseating the o-ring and tightening the bolts to 25 lbf-in in a criss-cross pattern.
The manufacturer says the Spot pattern is designed to be used in conjunction with additional Wide Driving and/or Driving/Combo beam lights.
Plan on a wiring harness before you start, since the pod ships bare; the manufacturer names 640175 as the applicable harness, and its upfitter catalog also lists a single-light LP4 harness, 640188. The LP4 install sheet specifies LP9, LP6, and LP4 Operating Voltage: 12-36 Volts. Keep the connector pins straight: DO NOT Power Pins 1 and 4 at the same time. This may cause damage to the circuit board - not covered under warranty. Wiring for two lights calls for 12 ga from power source, 14 ga from split junction. Unlike the larger LP9, the LP4 mounts without washers on the inside, so don't add them. Bring a 4mm Allen wrench and a torque wrench if you plan to change lenses later.
