The Borla 140733 is a cat-back exhaust for the 2010-2016 Audi B8/B8.5 A5 2.0L, with automatic or manual transmission, all-wheel drive, and the two-door body. The manufacturer builds it from T-304 stainless steel with CNC-cut, mandrel-bent pipework and its patented straight-through, multi-core muffler design. Its stated advantages over cheaper systems are the material and the build. The manufacturer says T-304 is superior to T-400 series knockoffs such as 409 for corrosion resistance and durability, and its smooth bends are meant to maintain flow. Owners on B8-platform forums describe the tone as an upgrade over stock that opens up after a few thousand miles. Dual oval 3.5 x 2.75-inch polished tips give the rear a finished look. Long-tail searches: 2010-2016 Audi A5 2.0T AWD cat-back, B8.5 A5 S-Type exhaust, T-304 stainless dual left rear exit.
Installation stays on the cat-back section, so the stock mid-pipe and catalytic converter remain in place. The system steps from 2.5-inch to 2-inch tubing and ends in dual left rear exits. Note that owners on user forums report that the stock hangers can be stubborn to free from their rubber isolators, so a flat-blade pry tool helps. The manufacturer's install sheet for this part recommends a professional exhaust installer and says a do-it-yourself install needs two people. Owners can use this as a reference for fitment and sound expectations, and the manufacturer should confirm trim-specific compatibility before purchase.
The manufacturer lists this system for the 2010-2016 B8/B8.5 A5 with the 2.0L engine, automatic or manual transmission, AWD, and two doors. Trim-level listings differ across sources, so confirm your specific trim and drivetrain with the manufacturer before ordering.
The manufacturer recommends an exhaust shop or professional installer. If you install it yourself, the manufacturer advises using two people rather than one for safety.
Per the manufacturer's install sheet for this part, the job is a two-person task that requires safe vehicle lifting and eye protection. Hangers seat into the rubber isolators, and the clamps stay loose until the full system is aligned and checked for clearance against the body, wiring, and tires. Avoid air impact tools on the fasteners, as the manufacturer's cat-back instructions warn they can bend flanges and cause leaks. Owners on user forums report that the stock hangers can be hard to free, so a flat-blade pry tool helps. After installation, start the engine and check every joint for leaks, since a loose clamp is the usual cause.