The Borla 140379 is a Touring-tuned cat-back exhaust for the 4.0L V6 Toyota 4Runner, built from T-304 stainless steel with 2.5-inch tubing, a straight-through muffler, and a polished 4.25" x 3.5" oval tip. The manufacturer says the system uses ultra-smooth mandrel bends and CNC-cut parts for a precise fit, and it is backed by a million-mile warranty. Stainless construction matters most on a 4Runner that sees road salt, since the manufacturer positions T-304 above cheaper T-409 knockoffs for corrosion resistance and longevity.
Compared with the factory system, owners on user forums describe a deeper, throatier note under throttle with a mellower cruising tone, and some report a bit more pickup. Drone is the most debated point. Many owners say the Touring tune stays quiet at highway speed, while others notice a hum at certain RPMs, especially on long grades. Because reports vary, check your tolerance for cabin drone before buying. For a 2010-2024 4Runner 4.0L 4WD owner who wants a stainless, no-drone-focused cat-back exhaust upgrade, this system is a practical choice. Vehicles with a turn-down tail pipe and no tip need the 140760 S-Type instead.
The manufacturer specifies that the 140379 fits vehicles with the original equipment exhaust tip. For vehicles with a turn-down tail pipe and no tip, the manufacturer directs buyers to the 140760 S-Type cat-back system.
Per the manufacturer, the 140760 is the S-Type model for turn-down tail pipes, while the 140379 is the Touring model that uses the original tip. The manufacturer describes the Touring sound as mellow, and the S-Type as the classic Borla sound.
Owners on user forums report mixed experiences. Many say the Touring tune is free of highway drone, while others report a hum at certain cruising RPMs or on long grades. Results can depend on the rest of the exhaust and intake setup.
Owners on user forums describe this as a bolt-on job that is manageable with basic hand tools, though the hardest part is usually removing the factory system. Owners recommend a 3/8" drive ratchet, extension, torque wrench, 15mm socket, pry bar, penetrating oil, and eye and hand protection, and one estimate put the job at roughly 1.5 to 2 hours. Lowering the spare tire first gives better access to the rear hangers. Expect seized or rusted fasteners, and confirm all pieces are present before cutting off the old system. One owner found a tack-welded pipe joint that required a different approach than expected, so inspect the old system before cutting.