The Borla 140347 is a cat-back exhaust for the MK6 Volkswagen GTI with the 2.0-liter turbocharged four-cylinder. A single 2.5-inch pipe runs back and divides into dual 2-inch outlets, finished with polished 4-inch tips in a single split rear exit. Per the manufacturer, it is built from T-304 stainless steel and uses patented technology to pursue more power and better fuel economy, with the S-Type tone kept free of cabin drone.
Against a stock system or a cheaper mild-steel option, the case for this one rests on materials and warranty. T-304 stainless resists corrosion, so the polished tips and welds hold up better over years of road salt and heat cycling. The manufacturer backs its GTI exhausts with a million-mile warranty. Buyers searching for a MK6 GTI 2.0T cat-back, an S-Type 140347 exhaust, or a 2.5 to dual 2 catback often want that durability as much as the sound.
Fitment covers 2010 through 2014 GTI models with the 2.0L 4-cylinder, automatic or manual transmission, front-wheel drive, in two- and four-door body styles. The manufacturer recommends professional installation, and if you do the job yourself it advises two people and a hoist or hydraulic lift. Plan for a full afternoon, and let the exhaust cool before you start.
Yes. The manufacturer lists it for automatic or manual transmission on front-wheel-drive 2010-2014 Golf GTI MK6 models with the 2.0L 4-cylinder, in both two- and four-door bodies.
The manufacturer recommends an exhaust shop or professional aftermarket installer. If you install it yourself, the instructions call for two people and a hoist or hydraulic lift.
Owners on user forums have raised concerns about tip fitment and heat damage near the exhaust cut-outs, mainly in older threads. Details vary, so confirm fit and heat clearance with the manufacturer before installation.
The manufacturer's install sheet lists a 3/8" drive ratchet, a 3/8" drive extension, a 13mm socket, a pry bar, and spray lubricant. The kit includes a front muffler assembly, right and left tail pipe assemblies, and one 2.5" and one 2" clamp. Wait at least an hour after driving before touching the exhaust, wear eye protection, and use a hoist or ramps with a second person to help hold the assembly. Spray the old hangers and clamps with lubricant before you pry them loose. Owners on user forums suggest checking the tip fit and the clearance around the cut-outs during the install, since those points have caused trouble for some buyers.