Borla's S-Type cat-back system (part 140383) is a vehicle-specific exhaust for the 6.2L V8 in the 2010-2014 Ford F-150 SVT Raptor. It runs a 3-inch pipe that splits into dual 2.5-inch outlets and is built from T-304 stainless steel, which the manufacturer specifies. Borla ties the design to its off-road racing background, including events such as the Baja 1000 and Best In The Desert. Compared with a generic universal exhaust, a bolt-on kit matched to the Raptor's pipe routing and mounting points avoids cutting or custom fabrication, and stainless construction holds up better than mild steel for owners who run mud, sand, and salt roads. This makes it a practical 6.2L Raptor dual exhaust upgrade for buyers searching for a stainless SVT Raptor cat-back.
Per the manufacturer, the system also fits the 2011-2012 Harley-Davidson Edition F-150 with the 6.2L V8, so buyers should check their trim against the listed years before ordering. Sources differ on whether the kit keeps or replaces the factory front muffler (resonator), and that choice changes the sound and the install steps. Confirm this detail with the manufacturer before purchase. Plan for a cat-back swap that includes the rear section and hangers, and check the hardware and gaskets included before you start the job in a driveway.
The manufacturer lists fitment for the 2010 through 2014 Ford F-150 SVT Raptor and the 2011 and 2012 Harley-Davidson Edition F-150, all with the 6.2L V8.
Sources conflict on this point, so details vary. Confirm with the manufacturer before ordering, because the answer affects both sound and installation.