The Borla 140760 is an S-Type cat-back exhaust for the 4.0L V6 4Runner, including TRD Pro trims. The manufacturer builds it from brushed T-304 stainless steel with a 2.5-inch pipe, and it finishes in a turn-down tail pipe, so it keeps the factory look rather than adding a tip. Pick this part over a generic stainless kit when you want a 2.5-inch S-Type sound with the right tail pipe for a factory-tipless 4Runner. The manufacturer says T-304 is the better choice over cheaper T-409 type stainless, and owners on user forums report a noticeably deeper note than the factory TRD exhaust, though reports on highway drone are mixed. Search terms this part answers include 4Runner TRD Pro S-Type cat-back, 2.5 inch turn-down tail pipe 4Runner, and Borla 140760 install.
Fitment is the first thing to confirm. The manufacturer's vehicle table for this part number lists 2015 through 2018 TRD Pro and Off-Road models with the 4.0L engine and 4WD, and says the system fits vehicles with the factory turn-down tail pipe. Owners on user forums describe installing it on earlier 5th-generation 4Runners as well, so compare your VIN and tail pipe style before ordering. For DIY work, the manufacturer's install guide covers this part number and calls for hangers set into rubber isolators with a hoist or lift. Owners describe about 1.5 to 2 hours with basic hand tools, and they recommend penetrating lube on the flange bolts behind the rear axle, since seized hardware is the usual delay.
The manufacturer states that 140760 is designed for vehicles with the O.E. turn-down tail pipe and no tip. For vehicles that have the factory tip, the manufacturer points to part 140379 instead.
The manufacturer's install guide walks through setting the muffler and hangers into rubber isolators and fitting the tail pipe with a supplied clamp. Owners on user forums describe the job as a straightforward DIY project, and they say corroded flange bolts and isolators are the most common delay.
Details vary. Some owners on user forums report highway drone with the S-Type, while others say it is quieter than the factory TRD exhaust. Results depend on the vehicle, so check expectations with the manufacturer before buying.
Owners rate this as a moderate DIY job that takes roughly 1.5 to 2 hours. Common tools include a 3/8-inch drive ratchet with extension, a torque wrench, a 15mm socket, a pry bar, penetrating lube, and eye protection. Start by removing the spare tire for working room, then soak and loosen the two flange bolts behind the rear axle and lube the rubber isolators before pulling the old tail pipe. Set the new muffler hangers into the isolators, slide the clamp over the tail pipe joint, and torque fasteners to the values in the manufacturer's install sheet. The manufacturer recommends a hoist or hydraulic lift, and the exhaust should be cool before you work on it.