Borla part 140356 is an ATAK cat-back exhaust for the 6.2L V8 in the 2010-2013 Chevrolet Camaro SS. The manufacturer lists it for automatic and manual rear-wheel-drive coupes and convertibles. It uses 2.5-inch piping that runs back to a single split exit with 4.5-inch rolled, angle-cut tips, so the car gets a louder and more aggressive note than stock without a custom fabrication job.
The reason to pay for this system over the factory exhaust or a cheaper generic cat-back is the combination of sound, flow, and warranty. Borla's own catalog places the ATAK tier above its milder S-Type cat-back for this car, which matters if you want the deeper muscle-car tone rather than a subtle upgrade. The manufacturer also backs Camaro SS exhausts with a million-mile warranty, which helps justify the price for a daily driver that will see years of heat cycles and road salt.
Fitment is the detail to verify before ordering. The manufacturer's S-Type listing is limited to cars without the Ground Effects package, and owners with that package should confirm with Borla which cat-back matches their car by option code. Borla publishes an installation instruction PDF for this part, and the system is marketed as a direct bolt-on. Long-tail searches this part answers include 2010-2013 Camaro SS 6.2L cat-back, Borla ATAK 140356 install, and Camaro SS 2.5 inch single split rear exit.
The manufacturer states that it offers a million-mile warranty on all Chevrolet Camaro SS exhaust systems, including this ATAK cat-back.
The manufacturer lists it for 2010-2013 Camaro SS models with the 6.2L V8, in automatic or manual rear-wheel-drive coupe and convertible configurations. Its S-Type cat-back is limited to cars without the Ground Effects package, so owners with that package should confirm fitment with the manufacturer before buying.
Borla provides an installation instruction PDF for this part, and the manufacturer describes the system as a direct bolt-on replacement for the factory cat-back. Review the instruction sheet before starting so you know the hanger points, hardware, and sequence. Support the exhaust while you remove the factory hangers, and work only on a vehicle that is safely raised on stands. For fastener torque values, follow the manufacturer's documentation rather than estimating, since the specs were not confirmed during research.