Borla part 140378 is a complete cat-back exhaust for the 2010-2013 Chevrolet Camaro SS with the 6.2L V8. It is built from 2.5-inch mandrel-bent T-304 stainless steel tubing and includes a merge X-pipe that feeds Borla's ATAK straight-through mufflers. The manufacturer lists it for Camaro SS coupes and convertibles with automatic or manual transmission, but only for cars equipped with the Ground Effects Package (GFX). Tips are not supplied, so the system bolts up to your factory rear valance and reuses the stock tips. Compared with the factory system, the manufacturer says the smoother piping and straight-through design improve exhaust flow, and ATAK is tuned for a loud, aggressive note without the drone and distortion common to louder exhausts. Searchers looking for a 2010-2013 Camaro SS GFX cat-back, ATAK 140378, or a merge X-pipe 2.5 inch stainless system will find the right part here.
Choosing this cat-back over a cheaper universal system makes sense because the fitment is specific to the GFX rear valance and the factory tip layout, which reduces modification work. Borla states that each system is handmade in the USA from T-304 stainless and carries its Million-Mile Warranty across its exhaust line. If your car does not have the Ground Effects Package, the manufacturer points to different Borla part numbers, so confirm your trim before ordering.
The manufacturer specifies this system for Camaro SS models equipped with the Ground Effects Package only. Borla lists separate cat-back and axle-back part numbers for SS models without that option, so check your trim before ordering.
No. The manufacturer states that tips are not included and that the system uses your factory valance and tips.
Yes. The manufacturer describes this as a complete cat-back that includes a merge X-pipe along with the ATAK mufflers.
Borla's cat-back is designed as a direct bolt-on replacement that mounts in the factory location without cutting, and it reuses the factory hangers. Expect roughly three hours with basic hand tools, which makes this a light-to-moderate job for a home garage. Owners on user forums report that the rubber hangers behind the stock system are the hardest part to reach, and that removing the rear diffuser makes them easier to pop out. Plan for enough clearance behind the car, since the stock exhaust comes out as one long piece and may need to be pulled out at an angle. Keep the factory tips and valance in place, because this system is built to use them.