Free Shipping on Orders Over $99  ·  No Code Needed

Borla 10-11 Toyota FJ Cruiser 4.0L 6cyl AT/MT SS Catback Exhaust

*Photo may not represent actual product

The Borla 140405 is a Touring-voiced cat-back exhaust for the 4.0L V6 FJ Cruiser, built to replace the factory tailpipe section. Borla builds it from T-304 stainless, a grade the company positions above the T-400 steels used in budget knockoffs, and uses mandrel bends and CNC-cut parts for a precise fit. The layout runs a 2.5-inch pipe that splits into dual 2-inch outlets and finishes in polished 4-inch tips at a split rear exit.

Choose this kit over a stock or budget muffler when the goal is a deeper, sportier tone with less cabin drone on long highway runs. The manufacturer says the Touring tune is meant to keep drone out of the cabin. Owners on user forums say the note is most noticeable under throttle and fairly subtle at idle, and one long-term owner reports the stainless tips and pipes have shown no rust after seven years. Borla's power language for this kit is general rather than quantified, so buy it for sound character and corrosion resistance, not for a published horsepower figure.

Fitment covers 2010-2014 Toyota FJ Cruiser 4.0L V6 models with automatic or manual transmissions in 2WD or 4WD four-door form. Borla's install guide for its S-Type sister system recommends a professional exhaust installer, but owners on user forums who handled the work themselves report that the tow hook can crowd the pipe run and that hangers sometimes need cutting and re-welding to level the tips. Soaking the flange bolts and rubber hangers with penetrating oil the night before makes teardown noticeably easier. Search terms this fits: FJ Cruiser 4.0L V6 cat-back exhaust, T-304 stainless FJ Cruiser exhaust, 2010-2014 FJ Cruiser Touring cat-back, low drone FJ Cruiser exhaust.

  • Part Number: 140405
  • Fitment: 2010-2014 Toyota FJ Cruiser, 4.0L V6, automatic or manual transmission, 2WD/4WD, 4-door
  • Sound Type: Touring
  • Pipe Diameter: 2.5 in. into dual 2 in. outlets
  • Tip Size and Finish: Single 4 in. round, polished T-304 stainless, one per side
  • Tip Style: Single round rolled, angle-cut, lined, resonated
  • Exit Position: Split rear
  • Material: T-304 austenitic stainless steel

FAQ:

Does this 140405 kit fit my 2010-2014 FJ Cruiser?

The manufacturer lists this Touring cat-back for 2010-2014 Toyota FJ Cruiser models with the 4.0L V6, automatic or manual transmission, and 2WD or 4WD in four-door form. Confirm your VIN-level configuration against the manufacturer's fitment chart before ordering, since the product title on some listings reads 10-11 only.

How does the Touring 140405 differ from the S-Type 140521?

The manufacturer positions the S-Type as its classic-sound option, built with a single 2.5-inch pipe, a single 4-inch tip, and a single right rear exit. The Touring 140405 uses a 2.5-inch pipe that splits into dual 2-inch outlets with a split rear exit, aimed at a mellower, low-drone tone.

Is this a DIY-friendly install?

The manufacturer's install guide for the sister S-Type system recommends an exhaust shop or professional installer, while noting that a DIY install is possible with the listed tools and careful hardware handling. The guide specifies flange hardware torque of 18-22 ft-lbs.

Installing it yourself

Per the manufacturer's install guide for the sister S-Type system on this platform, a DIY install calls for a 3/8-inch drive extension, a 15mm deep-well socket, a 14mm socket, and a pry bar, and the guide advises lubricating the threads and rubber isolators before removing the stock hardware. Keep all original hardware until the new system is fitted, then set the muffler assembly on the hangers and tighten the flange hardware to 18-22 ft-lbs. Owners on user forums warn that the factory tow hook can interfere with the pipe on some FJs, and that hangers occasionally need cutting and re-welding to get the two sides level, so check alignment and tip position before final tightening.

  • MPN: 140405
  • Manufactured by: Borla
  • Units per SKU: 1
  • In Stock: 5
Exclusive member pricing Free membership — sign in to see your price
Join Free →

$1,694.99

MSRP / List price
Member Price
Your price after signing in
$1,694.99
Only 5 left in stock — order soon
Add to Cart:
MPN
140405
Manufacturer
Borla
Availability
Only 5 left
Ships Same Day
Order before 5pm PST and this product ships same day
Member Pricing
Easy Returns
Expert Support
Secure Checkout