The Borla 140552BC is a Touring-series cat-back exhaust for the 5.7L V8 Ram 1500. Borla says the whole system is engineered from the catalytic converter back, so it is more than a muffler swap. The 3-inch pipe splits into dual 2.5-inch lines and ends in single 5-inch black chrome tips made of T-304 stainless steel, which the manufacturer lists as the material for this family. The Touring tuning is the draw for a buyer who wants a deeper, more aggressive note without a boomy drone at cruising speed, and the manufacturer describes it as mellow with no drone inside the vehicle. Search terms this part targets include 5.7L Hemi cat-back exhaust, through-bumper dual exhaust, and black chrome Touring cat-back.
Fitment is the first thing to confirm. The manufacturer lists this part for the 5.7L V8 with automatic transmission, in 2WD or 4WD, across regular, extended, and crew cab configurations with a standard bed. The tips must exit through the notched openings in the factory bumper. Borla's buying guide calls the 5.7L Hemi cat-back a bolt-on installation, which makes it a practical upgrade for a home mechanic with basic tools. Owners on user forums describe a straightforward install, though one reported grinding down alignment pins to seat the tailpipes into the muffler outlets.
The manufacturer's listing for this part covers the 2009 Ram 1500, 2010-2018 Ram 1500, and 2019-2024 Ram Classic 1500 with the 5.7L V8 and automatic transmission. Borla's own pages give differing notes on Classic-only coverage for 2019-2024, so confirm your model year and tip configuration with the manufacturer before ordering.
The manufacturer's install instructions for this family say a rear clamp may have grooved the pipe, in which case it may need cutting. Otherwise the work involves unbolting clamps and freeing the hangers from their rubber isolators.
The manufacturer's install guide for PN 140552 lists a 3/8" ratchet, a 3" extension, 10mm and 15mm sockets, and a pry bar, plus spray lubricant for the hangers and isolators. Borla recommends a professional exhaust shop, but owners on user forums report doing it at home in an afternoon with a lift or jack stands. Work from front to rear and leave the clamps loose until the tips are aligned, then tighten them. Do not use an air impact tool on the clamps, since that can bend flanges. Expect a possible need to grind the tailpipe alignment pins so the tailpipes seat fully in the muffler outlets.