Borla's S-Type cat-back for 2009-2013 Silverado 1500 and Sierra 1500 trucks runs a 2.75-inch pipe that splits into dual 2.25-inch tail pipes, with a 4-inch round chrome tip on each side. The tubing is T-304 stainless, which the manufacturer positions above cheaper 409-grade knockoffs for durability. Mandrel-bent pipe and CNC-cut components are meant to keep exhaust flow high and the fit accurate.
Compared with a stock exhaust, the case for this system rests on material, warranty coverage, and sound. Borla lists this part for the 4.8L, 5.3L, and 6.0L V8 engines on Extended Cab trucks with a standard 6'7" bed, and it backs its Silverado 1500 exhaust line with a million-mile warranty. Owners on user forums describe a clear sound upgrade over the factory system, which is the main reason many buyers choose an S-Type tone over a quieter Touring setup for their 5.3L or 6.0L trucks.
The manufacturer's listing for part 140429 names only the 4.8L, 5.3L, and 6.0L V8 engines. Borla's 6.2L installation guides cover different part numbers, so confirm your part number against the manufacturer's fitment listing before ordering.
Per the manufacturer's installation sheet, the factory pipe is cut between the muffler and the cross member, and the Borla pieces then clamp onto the cut ends. Details vary across sources on this point, so confirm the cut location with the manufacturer before starting.
The manufacturer's installation sheet lists the muffler, left and right intermediate pipes, left and right tail pipes, clamps, a hanger bracket, a rubber isolator, and heat shield reflex wrap.
This is a cut-and-clamp installation rather than a simple bolt-on, so expect a few hours of work. The manufacturer's sheet calls for cutting the factory pipe between the muffler and cross member, then clamping the new intermediate and tail pipes onto the expanded ends, with hangers seated in the rubber isolators. Owners on user forums report roughly two hours with one cut, performed on a garage floor. Soak the exhaust fasteners and hangers in penetrating lubricant well before you start, since rusted hardware is the most common delay. Borla's cat-back guides recommend two people, and its installation sheets warn against air impact tools on the flange hardware. Use a hoist or jack stands with a muffler stand, and tighten clamps only after the system is aligned and tip-centered under the valance.