Free Shipping on Orders Over $99  ·  No Code Needed

Borla 09-11 Chevrolet Corvette 6.2L V8 Aggressive ATAK Catback Exhaust

*Photo may not represent actual product

The Borla 140414 is a cat-back exhaust for the 2009-2011 Chevrolet Corvette C6 with the 6.2L V8, in both coupe and convertible body styles and with automatic or manual transmissions. It is built around Borla's ATAK tuning: the manufacturer says the muffler cores are calibrated for each vehicle to set the sound. The system uses T-304 stainless construction and a merge X-pipe, and the manufacturer describes the X-pipe as aimed at better power and sound. Owners on user forums describe the ATAK note as aggressive, and many say it is clearly louder than stock without the constant cabin drone they had with other systems, though reports of drone on cruise do appear, especially on cars with headers or cams. This fits buyers who want a bolt-on upgrade in the sound and appearance of a true performance exhaust over a cheaper, generic axle-back. Search terms: 2009-2011 C6 Corvette 6.2L cat-back exhaust, Borla ATAK 140414, C6 Corvette merge X-pipe exhaust, C6 cat-back no NPP valves, dual 4 inch polished tips C6 Corvette.

Fitment is the main purchase check. The manufacturer lists the 2009-2011 C6 with the 6.2L V8, and the system is compatible with cars that have or do not have NPP valves, but the NPP valves themselves are not included. The single 2.5-inch pipe feeds the mufflers, which exit through dual 2-inch outlets into dual 4-inch round polished tips. The system ships in two boxes. For the install, the system is a bolt-on job without cutting or welding. Owners on user forums say the rear over-axle sections come off easily once the rear spring hangers and pipe clamps are released, and that a lift or ramps make the work easier. Lubricating the rubber hangers before removing them helps, and a shop-style check of clamps and hangers afterward is important, since loose hangers can cause heat-shield rattles. Owners report the job takes roughly one to three hours. Check fitment and hardware in the manufacturer's installation sheet before you start.

```
  • Fitment: 2009-2011 Chevrolet Corvette (C6), coupe and convertible, RWD
  • Engine: 6.2L V8
  • Transmission: Automatic or manual
  • NPP compatibility: Fits vehicles with or without NPP; NPP valves not included
  • Exhaust type: Cat-back with merge X-pipe
  • Pipe diameter: Single 2.5" into mufflers, dual 2" out
  • Tip size and style: Dual 4" round, polished, angle-cut
  • Material: T-304 stainless steel
  • Sound profile: Borla ATAK
  • Shipping: Two boxes

FAQ:

Does this system fit 2012 or 2013 Corvettes?

The manufacturer's listing for this part covers 2009-2011 C6 Corvettes with the 6.2L V8. Confirm later model-year fitment with the manufacturer before ordering.

Do I need NPP valves to use this exhaust?

No. The manufacturer states the system fits Corvettes with or without NPP, but the NPP valves are not included in the kit.

Will it drone on the highway?

Experiences vary. Owners on user forums often report a clean, aggressive sound without constant cabin drone, while some report drone at cruising speed, especially on cars with headers or camshafts.

Installing it yourself

Owners on user forums describe this as a bolt-on job that is manageable for a home mechanic with a lift or ramps and a solid jack setup. Common steps include loosening the clamps, lowering the H- or X-pipe, removing the rear spring hangers, and sliding the over-axle sections off the axle. Some owners also loosen the wheelhouse liner bolts to reach the tabs holding the discharge vent. Pre-fit the pipes on the floor, lubricate the rubber hangers, and leave a little clearance at the rear so the system does not rattle as it settles. Expect the job to take roughly one to three hours, and recheck all hangers and clamps before starting the car.

  • MPN: 140414
  • Manufactured by: Borla
  • Units per SKU: 1
  • On Order: 4
Exclusive member pricing Free membership — sign in to see your price
Join Free →

$2,498.99

MSRP / List price
Member Price
Your price after signing in
$2,498.99
Add to Cart:
MPN
140414
Manufacturer
Borla
Availability
Out of Stock
Ships Within
1–2 Business Days
Member Pricing
Easy Returns
Expert Support
Secure Checkout