The FOX 981-20-041 is a 2.0-inch-diameter hydraulic bump stop from the Factory Race Series, built to control the last stretch of suspension compression. The manufacturer says Off-road Factory Race Series bump stops were developed with top off-road racing teams. Compared with a stock rubber or foam stop, this unit uses a built-in FOX Air Valve (FAV) to adjust nitrogen charge, so you can tune how firmly it engages instead of accepting one fixed feel. The durable construction and replaceable strike pad are meant to stand up to repeated hits, and the Cerakote-coated body and hard chrome 4130 chromoly shaft add durability for desert and rock-crawl use. Its 2.5-inch travel suits buyers searching for a 2.0 pinch-mount bump stop, Factory Race bump stop tuning, or an off-road bump stop with nitrogen adjustment.
The manufacturer lists this unit as a pinch-mount style. Owners on user forums report that a pinch-style can is needed to hold the bump stop, and that fitting it usually means lifting the vehicle and removing the coil springs first.
According to the manufacturer, the FAV valve allows nitrogen charge adjustments to change bottoming control. Confirm the correct pressure for your setup with the manufacturer's owner's manual.
The manufacturer states that the strike pad is replaceable and that the unit is owner serviceable and rebuildable.
Plan on a involved job rather than a bolt-on swap. Owners on user forums describe lifting the vehicle, pulling the coils, and sometimes cutting and welding a mounting hole, so a welder and a chassis lift are realistic requirements. Before you commit, check clearance at full compression: one owner on a Jeep found that a longer-travel bump stop brought an upper control arm into contact with a motor mount bracket, which required trimming the bracket. Plan on a full-travel check after installation and confirm the final stop position with the manufacturer.