The Fox 883-02-168 is a rear pair of Factory Race Series 2.0 bump stops that use an internal floating piston (IFP) design and are sized for the Jeep Wrangler JL. The body is threaded, impact extruded, black anodized, and CNC machined from 6061-T6 billet aluminum, with a hard chrome plated 1-1/4" 4130 steel shaft. The threaded body lets you set the mounting height, so you can tune where the stop starts to load during up-travel. Compared with a factory rubber stop that only cushions contact, this kit is meant to add controlled damping in the final inches of compression. The IFP separates the oil from the nitrogen, which is meant to prevent cavitation and bucking. Shoppers searching for Jeep JL rear bump stops, IFP bump stops for a 2.5 inch lift, and Fox 2.0 Factory Race rear bump stops will find the core application here.
This is a lift-dependent part, not a plug-in upgrade. The manufacturer's rear kit is labeled for lifts of 2.5 inches or more, so check your rear lift before ordering. The front pair is a separate part number, 883-02-167. Coverage is listed as 2018-2025 in some places and 2018-2026 in others, so confirm model-year fitment with the manufacturer. Buyers who run an aftermarket long-travel or lifted setup should also consider clearance with the new stop, since the manufacturer notes that modifications are required for installation.
No. The manufacturer labels the rear kit for lifts of at least 2.5 inches, so a stock or lightly leveled rear is not a suitable application.
No. The manufacturer's installation guide identifies 883-02-167 as the front bump stop kit for the JL, while 883-02-168 is the rear pair.
The manufacturer lists modifications as required for this product. Its rear instructions for a related Jeep bump stop kit call for welding a chassis tube to the frame, so confirm the exact procedure for 883-02-168 in the manufacturer's guide before starting.
Plan on a chassis lift and secure jack stands; the manufacturer's guides say to block the wheels and never work under a vehicle that is not stable. The manufacturer's instructions call for removing the factory bump stop from its holder, then placing and welding the new chassis tube in position before threading in the Fox stop. Estimates for install time and skill level vary, from roughly 2 hours of light-to-moderate work to 3-5 hours for an expert, so budget conservatively. Measure and mark the cut line carefully, make sure the cut surface is square, and weld around the entire tube. Use medium-strength threadlock on all bolts, and set the bump height by threading the stop until it lands at the desired engagement point.