This FOX 2.0 Internal Floating Piston (IFP) rear bump stop, part 883-02-155, is a threaded aluminum bump stop built for the rear axle of 2007–2018 Jeep Wrangler JK models. The IFP reservoir separates the oil from the nitrogen, which helps the damper resist cavitation and bucking when the suspension compresses hard. Its threaded body lets you raise or lower the engagement height, so you can decide when the stop starts working. That adjustment matters most on a lifted JK, where the rear axle travels farther before it reaches the stop.
The body is 6061-T6 billet aluminum, black anodized, with a hard-chrome 4130 steel shaft, a heavy-duty powdered steel piston, and a redundant seal pack. The Delrin strike pad can be replaced without buying a new unit, and the bump stop can be rebuilt and serviced, which gives it a longer service life than a disposable rubber stop. The integrated FOX air valve sits at the bottom of the shaft, so you can adjust nitrogen pressure to fine-tune bottoming control. Buyers searching for a Jeep JK rear 2.0 IFP bump stop, a Wrangler JK rear bump stop with air valve, or a serviceable Fox 2.0 bump stop for a lifted JK will find this part a fit for those needs.
Installation involves unbolting the factory-style rear bump stop bracket and fitting the threaded unit with its included hardware, which is why a straightforward bolt-on job is possible for a home mechanic with basic hand tools and a jack and stands. Expect to set the mounting height and check that the stop engages where you want it. Listings for this part differ on whether modifications are needed: some note that the unit requires modifications and one notes that cutting and welding may be required, so confirm the fitment requirements with the manufacturer before you start. The nitrogen pressure at the FOX air valve should be set to match your lift height and load.