The EBC GD7389 is a front brake rotor from EBC's 3GD Series Sport line, a one-piece vented rotor with dimpled and slotted faces. It is built for the 2007-2008 Lexus GS350 3.5 RWD. The manufacturer says EBC rotors are made from OE-spec grey cast iron. The cross-drilled-style slotting and dimpling are meant to move heat, water, and debris away from the pad face, which matters on a heavier rear-drive sedan that sees repeated spirited stops.
The main reason to choose this over a stock rotor is cooling and resistance to distortion. The manufacturer notes that the 3GD design uses a wider vented aperture so air can pass between both rotor faces, which lets the metal expand evenly and reduces the chance of warping. That same vented centre is why the GD7389 suits enthusiasts chasing consistent pedal feel on back-to-back stops. Confirm fitment before ordering, since the model years and drivetrain variants listed for this rotor differ from source to source. Search terms that match this part include GS350 RWD sport front rotors, EBC 3GD dimpled slotted rotor, and 2007 2008 GS350 front brake upgrade.
Owners on user forums report that the caliper must come off, and the rotor can then be pulled from the hub. Keep the caliper hanging on a line rather than letting it rest on the brake hose.
User forums describe tapping the rotor with a hammer, then threading a bolt into the rotor's puller holes to push it off the hub. Posters report different bolt sizes, so check the thread size on your own rotor before buying a puller bolt.
Fitment listings for this rotor disagree on model years and on whether AWD versions are covered. Confirm your VIN and drivetrain with the manufacturer before ordering.
Owners on user forums describe this as a manageable driveway job once the caliper is off. You will need a standard socket set, a hammer, and a way to pull a stuck rotor. Replace the pads and shims at the same time, and clean the hub face and the rotor's mounting surface before refitting. Forum members also report that the rotor may be seized to the hub from corrosion, so penetrating oil and patience help. Because bolt sizes reported for the stuck-rotor puller differ, check your own hardware before starting. Torque values should come from the manufacturer or a service manual rather than forum posts.