The EBC GD1524 is a rear vented disc for the 2007–2010 BMW X5 3.0, built on EBC's GD Sport line, which uses wide aperture slots and dimple drilling, with a gold anodised finish on the listed design. Compared with a stock rotor, the wide slots are meant to help the disc shed gases, dust, and debris from the pad face, which can lower the temperatures that lead to brake fade on repeated stops. Blind-drilled dimples are used instead of through-holes, which reduces the crack-initiation points that drilled rotors are known for. Each disc is precision machined in the UK from R90-approved blanks, and is inspected for runout before shipping, so a buyer gets a more consistent starting point than a generic cast disc. Searches for "BMW X5 E70 3.0 rear sport rotors," "E70 slotted dimpled rear brake rotor," and "X5 3.0 FMSI D1042 rotor" will lead you to this part.
Fitment targets the rear axle of the 07–10 X5 3.0 and uses a 5x120 bolt pattern with a 75 mm center bore, and it is designed around the FMSI D1042 pad reference, so pad selection stays straightforward. The listings I reviewed describe the disc at 320 mm diameter, 20 mm new thickness, and 79 mm height, with a minimum thickness of 19 mm. Check the minimum thickness stamped on the disc and the wear limit before installation. Finish descriptions differ between listings, with some calling the coating silver-grey corrosion-resistant and others describing a gold or black tone; confirm the exact finish with the manufacturer before ordering if appearance matters to you. Owners who want a matched setup should plan the pad choice alongside the rotor purchase.
The GD1524 is listed for the rear axle of the 07–10 BMW X5 3.0 and uses the FMSI D1042 pad reference. Some listings describe a wider X5 and X6 range, so confirm your VIN-specific fitment with the manufacturer before ordering.
It is sold as a pair, so one set covers both rear sides. Pads are not included with the rotor listing and need to be purchased separately.