Free Shipping on Orders Over $99  ·  No Code Needed

EBC 06-09 Chrysler Aspen 4.7 GD Sport Front Rotors

*Photo may not represent actual product

The EBC GD7105 is a front slotted sport rotor from EBC's GD Sport line, made for the 06-09 Chrysler Aspen 4.7 V8. The wide-aperture slots are the core of the design. The manufacturer says they draw cooler air across the pad-to-rotor interface, keep pad wear even, and clear dust, mud, water, and debris from the braking zone. Dimpled holes allow pad degassing without through-drilling, which the manufacturer links to avoiding stress cracks. Fade on a heavy SUV usually starts with heat, and that is where this design helps.

Buyers searching for a 4.7 Aspen front brake upgrade usually want fade resistance when towing, a cleaner pad-contact surface, and a corrosion-protected finish that holds up in salt-belt winters. The GD7105 justifies its price over a basic replacement rotor through its slot geometry and coating, though finish details vary by production run, so confirm the current coating with the manufacturer before ordering. Owners on Chrysler enthusiast forums have reported brake judder appearing months after a rotor swap, which makes hub prep, lug torque, and bedding as important as the part itself.

  • Manufacturer Part Number: GD7105
  • Application: 2006-2009 Chrysler Aspen, 4.7L V8 (confirm fitment with the manufacturer before ordering)
  • Position: Front
  • Sold As: Pair (the manufacturer advises replacing rotors in pairs)
  • Design: Wide-aperture slotted, dimpled GD Sport rotor
  • Finish: Corrosion-protective coating; color and coating vary by production run, confirm with the manufacturer
  • Pad Requirement: New pads must be fitted when new rotors are installed

FAQ:

Do I need new brake pads when I install these rotors?

Yes. The manufacturer states that new pads must always be fitted after installing new rotors, since worn pads on new rotors can create hot spots and cause rotor damage.

Can I replace only one front rotor?

The manufacturer advises always replacing rotors in pairs.

What runout tolerance should I check before fitting pads?

Per the manufacturer's install sheet, runout must not exceed 0.08mm. If it does, remove the rotor, rotate it one bolt position, reseat it, and measure again.

Does the GD7105 need a bedding-in procedure?

The manufacturer's install sheet calls for following its bedding-in procedure once the new rotors and pads are installed. Follow that procedure rather than a generic one.

Installing it yourself

Per the manufacturer's install sheet, you will need a dial indicator for runout, a jack and axle stands, wheel chocks, the correct wheel socket, a torque wrench set to the vehicle's specification, and brake cleaner with a clean rag. Clean the wheel hub thoroughly first, because the manufacturer identifies poor hub condition as the leading cause of rotor runout. Place a washer between each wheel nut and the rotor, hold the rotor with the nuts loosely tightened, then check runout before final torque. Owners on user forums report that rotors can stick to the hub with rust, so penetrating oil and patience help. A front rotor swap is a reasonable home-garage job for someone comfortable with brake work.

  • MPN: GD7105
  • Manufactured by: EBC
  • Units per SKU: 1
  • In Stock: 6
Exclusive member pricing Free membership — sign in to see your price
Join Free →

$365.87

MSRP / List price
Member Price
Your price after signing in
$365.87
In Stock — ships same day if ordered before 5pm PST
Add to Cart:
MPN
GD7105
Manufacturer
EBC
Availability
In Stock (6)
Ships Same Day
Order before 5pm PST and this product ships same day
Member Pricing
Easy Returns
Expert Support
Secure Checkout