The EBC GD7199 is a rear brake rotor for the 2004–2008 Acura TL 3.2 with automatic transmission. It belongs to EBC's GD Sport line, which uses grey iron rotors with a dimpled and slotted face. The manufacturer says its dimpling was developed to allow pad gas and dust to escape without through-drilled holes, which are more prone to cracking. The slots are meant to clear debris from the pad contact area and reduce fade under repeated hard stops. Compared with a plain OE-style rotor, this design is aimed at drivers who want steadier stopping power on spirited back roads or occasional track days without the noise and cracking risk of drilled rotors. Search terms this rotor matches include 2004 Acura TL 3.2 automatic rear rotors, EBC GD7199 slotted dimpled rear rotor, TL rear brake fade upgrade, and dimpled rotor crack resistance.
Fitment is built around the rear axle of the 2004–2008 TL 3.2 automatic, so confirm your trim and transmission before ordering. Because the rear rotor shares its hat with the parking brake shoes on this generation, the job is more involved than a front swap. Owners on user forums report that the rotors often seize to the hub from rust. Plan on penetrating oil, a rubber mallet, and possibly a drill or impact driver to remove the retaining screws. Replace the pads at the same time so the new rotor seats against fresh friction material from the start. The work is manageable for a home mechanic with basic tools and patience.
Owners on user forums say rust is the usual cause on the TL rear. Remove the caliper, use penetrating oil around the hub, and tap the rotor with a rubber mallet. Stubborn rotors can be pushed off by threading an 8 mm x 1.25 bolt into the rotor's tapped holes.
Owners on user forums report that the rotor has a rubber plug on its face. Removing the plug lets you reach the parking brake adjuster with a flat screwdriver. Rotating the rotor to align the adjuster and backing off the brake lets the rotor clear the shoes.
Difficulty is moderate and depends mostly on corrosion. Raise the vehicle, support it on jack stands, and remove the wheel. Take out the two caliper bolts on the back of the caliper, hang the caliper from the coil spring with zip-ties or wire so the brake line is not strained, and leave the pads on their bracket unless they are being replaced. Remove the screw or screws holding the old rotor to the hub. If the rotor is seized, use penetrating oil and tap it gently. Clean the hub face and remove any rust before fitting the new rotor. Install the rotor, reassemble the caliper and pads, and torque the caliper bolts and wheel lug nuts to specification. Before driving, pump the brake pedal until it is firm and check the parking brake. Tools needed: jack and stands, socket set, screwdriver, penetrating oil, rubber mallet, and a drill or impact driver if the screws are seized.