The EBC GD729 is a front GD Sport rotor with wide slots and dimpling, cast from G3000 grey iron. Per the manufacturer's description, the rotors are made in the UK, balanced, and inspected for runout piece by piece. The slots are wide and sweep the full face, which the manufacturer says expels dust, water, and gases and lowers pad temperatures under heavy braking. The dimpled face is EBC's signature design and is meant to reduce stress cracking. A thermic black finish protects against corrosion, so these are a step up from a plain stock disc for a 2.2L Impreza or a 2.5L Saab 9-2X built for spirited street and light track use. Enthusiasts searching for "EBC GD Sport front rotor 2.2 Impreza upgrade" or "Saab 9-2X 2.5 slotted dimpled rotor" will find this a direct-fit application.
Before ordering, confirm fitment. The listed application is the 2004-2006 Saab 9-2X 2.5L and the 1995-2001 Subaru Impreza 2.2L, excluding WRX models, but published fitment tables disagree on years and trims, and some list other Subaru and Saab trims. Check your VIN against the manufacturer's application data. For the install, plan to replace pads at the same time, since owners on user forums say uneven pads ruin a new flat rotor. Use synthetic brake lube on caliper slides and pad shims, and bed the new pads and rotors in properly. Owners on user forums also recommend checking that the brake dust shield is not bent and that the caliper bracket-to-spindle bolt is tight to avoid noise.
The listed application is the 04-06 Saab 9-2X 2.5L and the 95-01 Subaru Impreza 2.2L, excluding WRX models. Fitment tables disagree on years and trims, and some list other Subaru models. Confirm the fit against your VIN with the manufacturer before ordering.
Owners on user forums describe driving fairly hard for a few minutes to heat the rotors, then parking the car and letting the brakes cool fully before normal use. Each pad manufacturer has its own bedding procedure, so follow that as well.
Owners on user forums report that a bent brake dust shield can rub against the rotor, and that a loose caliper bracket-to-spindle bolt causes noise. Pads with higher metal content also tend to squeal more than stock pads.
This is a standard front rotor replacement, and owners on user forums recommend doing pads at the same time so the new rotors seat evenly. Use synthetic brake lube on the piston seals, caliper slide pins, and the backs of the pad shims, and move the shims over from the old pads if they are still in good shape. After reassembly, check that the dust shield is straight and the caliper bracket bolts are tight. The manufacturer's torque specifications for this application were not confirmed during research, so use the factory service manual values, and bed the brakes in using the pad maker's procedure.