The EBC GD1344 is a front rotor from EBC's GD Sport line, a dimpled and slotted vented design for the 2005-2007 Subaru Impreza WRX STI. The manufacturer says its wide slots draw cool air across the braking surface, and its dimpled faces let pad gases escape without through-drilled holes, which it links to rotor cracking. Against a stock rotor, that combination targets the heat buildup and fade that show up during repeated hard stops on a turbocharged AWD car. The manufacturer describes the grey iron as OE-spec material. Slotted faces do make more brake air noise than a plain rotor, so buyers who want silence should keep that in mind.
Fitment lists for this part are inconsistent across the market, so confirm your exact year, trim, and caliper setup with the manufacturer before ordering. The 2005-2007 WRX STI is the application most consistently associated with this rotor, and owners on user forums describe it as a bolt-on swap that uses factory calipers and hardware. Searches for 2005-2007 WRX STI front slotted rotors, dimpled slotted STI brake upgrade, and GD Sport fade resistance point to the buyers this rotor suits.
The manufacturer explains that dimpling lets brake pad gases escape without the through-holes of a drilled rotor, which it says can promote cracking. Slots add cooling and help clear debris from the braking surface.
The manufacturer's installation guidance calls for a bedding-in procedure after the first 200 miles of gentle driving on a quiet road, with medium-pressure stops that avoid bringing the vehicle to a full stop while the brakes are hot.
Fitment data for this part varies between sources, so the manufacturer should be consulted with your VIN or exact model year and trim. The 2005-2007 WRX STI is the most commonly cited application, and owners on user forums report a direct bolt-on fit.
This is a manageable front brake job for a home mechanic with basic hand tools and a safe lift setup. Owners on user forums describe removing the caliper bracket and lifting the caliper off the hub, then sliding the old rotor off. If it sticks, threading bolts into the release holes in the rotor face pushes it free. Check runout after mounting, and if it reads high, rotate the rotor one bolt position at a time to find a better seat; this follows the manufacturer's general rotor guidance. Bed in the new rotors with gentle driving first, then perform the controlled stops described in the bedding section above. Torque all wheel and caliper fasteners to the factory specification.