The EBC GD1490 is a pair of rear sport brake rotors for the 2002-2003 Mini Hardtop 1.6 (R50). Its dimpled and slotted design uses wide-aperture slots that pull air across the friction surface, and blind-drilled dimples that help vent gas and debris. That combination targets brake fade during repeated hard stops and cleaner pad contact, which suits enthusiasts who want more cooling than a stock solid rear disc gives them, without through-drilled holes.
Installation is a practical bolt-on job for a home mechanic with jack stands. The rotor is retained by a single T50 Torx screw, and it usually lifts off once the caliper and bracket are out, though a stubborn rotor may need a rubber mallet. Rear pistons on this chassis must be rotated while they are pressed back, because the parking brake uses the pads, so a plain C-clamp will not do the job. Keep grease off the new rotors and pads, and use anti-seize on the retaining screw. Anyone searching for dimpled slotted 259mm rear rotors for an R50 Cooper 1.6 should confirm fitment by VIN before ordering, since Cooper S and John Cooper Works cars run different brake hardware.
Difficulty is moderate for a competent DIYer. Plan on a T50 Torx bit, a torque wrench, a rubber mallet, brake cleaner, and a piston-rewind tool that can rotate the rear pistons. Loosen the lug nuts before raising the car, check the rotor markings for left and right orientation, and torque caliper and bracket hardware to the values in a factory service manual rather than relying on a general chart. Clean the hub face before seating the new rotor so it sits flat and runs true.