The PowerStop K704 is a front brake upgrade kit from the Z23 Evolution Sport line, pairing carbon-fiber reinforced ceramic pads with drilled and slotted rotors and stainless-steel hardware. The manufacturer describes the formula as delivering fade-resistant braking with cleaner wheels for daily driving, which is the case for spending more than stock pads cost. Rotors get a silver zinc dichromate finish that resists rust, and the rounded slots help clear gas and debris from the pad face. Buying the pads and rotors as one matched set from the same brand avoids mixing friction materials on a front axle.
This kit is listed for the 1997-2001 Acura Integra, but published fitment data differs on which trims are covered, so confirm your exact trim before ordering. Owners searching for a bolt-on Integra front brake upgrade, Z23 carbon ceramic pads, or drilled slotted rotors for a 1997-2001 Integra daily driver should check the manufacturer's application list first. Because the kit is designed as a direct-fit replacement, a standard front brake job with no modifications is the expected install.
The manufacturer offers its Z23 kit with powder-coated calipers as a separate product, so the standard K704 should be treated as pads, rotors, and hardware only. Check the packing contents on arrival before starting the job.
The manufacturer's installation guide lists a caliper piston compressor or C-clamp, a jack and jack stands rated for the vehicle, wheel chocks, brake component lube, and brake fluid as specified in the owner's manual. Safety glasses and gloves are also recommended.
Yes. The manufacturer says break-in is critical for consistent braking and quiet, trouble-free performance, and notes that proper pad bedding can prevent rotor warping. Its general Z23 guidance (shown on its European-vehicle Z23 kit page) calls for about 30 decelerations from 30 mph to 5 mph with cooling pauses between them.
This is a standard front disc job: lift and support the car on jack stands, remove the wheel, unbolt the caliper, and hang it from a hanger so the hose is never stressed. Before removing the old rotor, check for retaining screws, and expect rust to bind the rotor to the hub, which may need a mallet. Compress the caliper piston with a C-clamp or compressor while watching the brake fluid reservoir, which the manufacturer says should sit about half full. After the install, follow the manufacturer's break-in procedure so the new pads and rotors bed properly.