The Z23 pads combine with drilled and slotted rotors in this front-axle K694 kit for the 93-95 Honda Civic. The manufacturer describes its carbon-fiber ceramic pads as a low-dust formula that adds braking power, so the wheels stay cleaner than with a basic pad swap. Owners on user forums have reported mixed results: one owner said the kit kept stopping strongly for daily driving, but the pad eats up a bit quickly. The matched pad, rotor, and hardware package is built as a system upgrade rather than a pad-only change.
Break-in matters with this kit. The purpose of a proper break-in is to lay down an even layer of friction material on the rotors from the pads. The manufacturer's sequence starts with rapid stops from 40 mph down to 10 mph, follows with stops from 35 mph to 5 mph, and ends with a full cool-down before normal use. The kit also includes premium stainless-steel hardware and pin bushing kit for easy, problem-free installation, plus a Hi-Temp Brake Lubricant. If you're searching for a K694 front brake upgrade, Z23 Evolution Sport carbon ceramic pads, or a 93-95 Civic drilled and slotted rotor kit, this is the complete front-axle set. A forum reply notes that DOT 4 fluid has a higher boiling point than the DOT 3 fluid the factory uses, though it should be changed yearly.
The manufacturer also sells a Z23 Evolution Sport version with powder coated calipers. The K694 is the pad-and-rotor option, so it suits buyers who plan to keep their existing calipers.
Yes. The manufacturer calls the break-in procedure critical to brake performance and asks owners to complete the stop sequence before using the brakes normally.
Owners on user forums suggest DOT 4 fluid over the DOT 3 fluid the factory uses, because of its higher boiling point. Forum posters also recommend changing it about once a year. Confirm the correct fluid for your car in your owner's manual.
The manufacturer positions this kit as a bolt-on upgrade, so a driver comfortable with jack stands and basic hand tools can handle it. Gather a jack, jack stands, a C-clamp for pushing the caliper piston back, pad grease, and the brake fluid your owner's manual specifies, as the install guides for similar Power Stop kits list the same parts. Use brake grease only on the backing plate edge where it slides against the caliper bracket, and keep grease off the friction material. Don't let the caliper hang from its brake hose during the job. After installation, holding the brake pedal on hot rotors can imprint the pads and may cause judder, so avoid holding the pedal while the brakes are hot.