The Power Stop K408-26 is a rear Z26 Street Warrior brake upgrade kit that pairs two Z26 carbon-fiber ceramic pads with two drilled, slotted, and zinc-plated rotors, plus stainless-steel hardware and high-temperature brake lubricant. It is aimed at street drivers with high-horsepower or modified cars who want shorter stops than stock without moving to a track-only compound. Compared with a basic stock-replacement kit, the drilled and slotted rotors help vent heat during repeated hard stops, and the stainless-steel shims are designed to keep braking quiet. Search terms for this part include Acura Integra rear Z26 brake kit, carbon-fiber ceramic pads Integra, and drilled slotted rear rotors Integra.
Fitment is listed for the 1990 to 2001 Acura Integra, but trim coverage differs between sources, so buyers should confirm their exact year and trim with Power Stop before ordering. The kit is a pad-and-rotor replacement that reuses your existing rear calipers, so it only applies to cars that already have rear disc brakes. Owners on user forums report that some early Integras were built with rear drums, which this kit cannot simply bolt onto. For installation, the job is a rear-axle pad and rotor swap that most home mechanics can complete with a jack, stands, and basic hand tools. Be sure to lubricate only the pad contact points and never the friction surfaces, then follow the bedding procedure before driving hard.
Owners on user forums quote Power Stop's published procedure as five moderate to aggressive stops from about 40 mph down to about 10 mph, without coming to a complete stop and without letting the brakes cool between stops. Proper bedding helps lay an even friction layer on the rotors and can help prevent pedal pulsation.
Owners on user forums generally recommend using the stainless hardware and shims included in the kit, cleaning the pins and caliper bracket before reinstalling, and lubricating the slide pins. Reusing worn factory shims is commonly discouraged.
This is a bolt-on rear pad and rotor job that suits a home mechanic with basic tools. You will need a floor jack, four jack stands, a ratchet, a torque wrench, and the correct socket for the caliper slide-pin bolts, which should be checked on your car before you start. Remove the wheels, hang the caliper from a wire or coat hanger so the brake hose is not stressed, and clean the caliper rails and the rotor hub surface. Watch for these common gotchas: install the wear indicator tab on the inside pad, apply high-temperature lubricant only where the pad contacts the caliper, check rotor runout, and bleed the brakes if any bleeder valve was opened or a line was loosened. Do not skip the bedding procedure after installation.