The Power Stop Z26 Street Warrior front brake kit (K699-26) is a bolt-on front brake upgrade for the 1990–2000 Honda Civic. It pairs Z26 carbon-fiber ceramic pads with drilled and slotted rotors and stainless-steel hardware. The manufacturer recommends the kit for high-horsepower, modified and performance street cars, and says the drilled and slotted rotors and ceramic pads together aim to shorten stops under demanding conditions. Buying the pads, rotors and hardware as one matched set avoids mixing components from separate brands, which matters when you want predictable bite and pedal feel from a front brake setup.
Owners on user forums often describe low brake dust and quiet street manners compared with stock pads, though some report fade during repeated hard stops and a firmer initial bite, so bedding in matters. The manufacturer's break-in routine calls for five moderate stops from 35 to 5 mph in rapid succession without letting the brakes cool, and it notes that a resin smell is normal as the pads heat up. Shoppers searching for a 1990–2000 Civic front brake upgrade, Z26 ceramic pads, or a drilled and slotted rotor kit for a Civic will find this kit covers all three needs. Confirm your exact year and trim before ordering.
The manufacturer's listing for this version describes pads, rotors and stainless-steel hardware. The manufacturer offers the Z26 Street Warrior with powder-coated calipers as a separate kit, so check the part number before ordering.
The manufacturer's break-in procedure calls for five moderate stops from 35 to 5 mph in rapid succession without letting the brakes cool. Afterward, the manufacturer advises driving at moderate speed for about five minutes without heating the brakes excessively or coming to a complete stop, so the system can cool gradually.
This is a standard front disc brake job that generally takes a few hours with basic tools: a floor jack, jack stands, a torque wrench, a caliper tool, and a socket set. Work with the vehicle on level ground, chock the rear wheels, and keep the caliper hanging from a strut or hook rather than from the brake hose. Owners on user forums report that the front retainer supplied with some Power Stop kits can be too wide, and that reusing the original clip can be the fix. Check rotor clearance against the pad slides after installation, and confirm the pad shims sit correctly. If you open a bleeder or loosen a line, bleed the brakes before driving.