The PowerStop Z36 Truck & Tow pad set (part Z36-2491) pairs carbon-fiber ceramic friction material with stainless-steel hardware for the rear axle of the 2023-2024 Ford F-250 Super Duty. The manufacturer describes the Z36 compound as a low-dust, quiet formula built for heavy towing, hauling, and off-road use, while still being manageable in everyday driving. That combination is the case for paying more than factory pads: you get more stopping capacity when a trailer or payload is adding load, with less brake dust settling on your wheels. Premium stainless-steel shims are part of the design, and the manufacturer says they help dissipate heat for quieter braking.
Because the hardware is included, you can rebuild the rear brakes with fresh clips and slides rather than reusing worn parts, which is the most common reason a pad swap gets noisy. The manufacturer calls brake replacement a job most owners can handle at home and provides step-by-step install guides. Plan on a proper bed-in once the pads are installed: the manufacturer treats break-in as critical, expects a resin smell as the pads heat up, and says correct bedding helps prevent rotor warping and judder. Search terms this set targets include 2023 F-250 rear brake pads, Z36 carbon ceramic Super Duty pads, low-dust truck brake pads for towing, and 2023-2024 F-250 rear pad replacement.
The manufacturer says a proper break-in procedure is critical to brake performance because it lays an even friction layer on the rotors. Expect a resin odor when the brakes first heat up, and follow the manufacturer's bedding procedure to help prevent rotor warping.
Yes. The manufacturer's Z36 Truck & Tow brake kit includes premium stainless-steel hardware for a bolt-on installation.
The manufacturer describes replacing brakes as an easy job to tackle on your own and offers step-by-step installation guides for its Z36 products.
Expect a moderate, one-axle brake job. Raise the truck and support it on jack stands at the manufacturer's recommended lift points, and chock the front wheels. Basic tools include a socket set, torque wrench, a C-clamp or similar tool to push the caliper piston back, and brake grease. Retract the piston before fitting the thicker new pads, and protect the piston face with an old pad. Lubricate the backing plate edges and caliper bracket slide surfaces with brake grease, and keep it away from the friction faces. Torque the caliper bolts to specification and bed the new pads as described above before any hard towing.